AKG WMS 80 - RMU 40RMU 60 MOUNTING Operating instructions

Page 1 of 3

1. RMU 40 (7615H0604) for SR 40 Diversity

Consists of short and long rack ear, coupling plates and screws.

For mounting two SR 40 Diversity two RMU 40 are needed. Remove the rubber pads at

the bottom of the receivers where they are attached together and use the coupling plate

for linking the housings. Two short rack ears are to be mounted to the sides of the

coupled receivers. The long ears remain unused.

AKG RACK MOUNT KITS FOR WIRELESS RECEIVERS

Page 2 of 3

2. RMU 60 (2455Z0052) for SR 40 (non diversity version only), SR60/61 and SR80/81

This picture shows of which parts the RMU60 consists (2 Rack ears, 3 Coupling pieces,

Blind panel, Set of screws)

Correct positioning of rack ear and coupling piece. The blind panel is already fixed to the

rack ear using screws, toothed washers and nut

Page 3 of 3

The rack ears are put in place and the coupling piece is inserted into the side slots of the

SR. By turning the Phillips screws the two parts of the coupling piece are pressed against

the rim of the receiver's slots and safely fixed.

RMU60 attached to a single SR80 receiver

Finally fasten the securing screws after adding the washers

______________________________________________________________________

AKG Acoustics GmbH, A Harman International Company, Lemböckgasse 21-25, A-1230 Wien, Austria

Phone: (+431) 86654-1519, Fax: (+431) 86654-1514, e-mail: ser[email protected]

This manual is also suitable for

Download PDF