How to Connect and Charge
You should recharge your book light when it becomes too dim and avoid running the
battery completely down to help prolong battery life.
To recharge, attach the barrel end of the USB cable to the base of the light and connect
the USB connector to the charger. Plug the charger into a power socket and charge for
approximately 6 hours or until the light turns from red to green.
Care and Safe Use of Your Book Light
This is not a child's toy and not intended for young children.
- Do not charge below temperatures under 0°C.
- Keep away from fire, water and high temperatures.
- Never disassemble or short circuit the unit.
- Avoid excessive shock or vibration.
- If unit has leaking fluids, do not touch fluids, wash hands immediately.
- Unit contains Li-ion battery which is subject to disposal and recycling regulations.
Charger Safety Instructions
- Always use a charger supplied with the device or recommended by the manufacturer.
- Please note the charger can become hot during the charging cycle.
- Do not attempt to open the charger.
- Keep and use the charger in a dry place (indoor use only).
- Risk of electric shock.
- In order to avoid the risk of fire and/or electric shock, the charger must be protected
against high humidity and water.
- Disconnect charger when not in use.
- Do not leave charging unattended e.g. overnight while you’re asleep, or if you go out for
any significant length of time.
- Do not use the charger if there are any signs of damage to the housing, mains, pins,
cables or connectors.
LuminoLite are not responsible for the consequences, whether direct, indirect or
accidental, or for any other type of damage arising or resulting from the improper use of its
products.