USER MANUAL
LED-5300
120 LED DIMMABLE ON-CAMERA LIGHT
LED-5300 - USER MANUAL
2
Thank you for choosing the Genaray LED-5300 On-
Camera Light. This product will provide you with
powerful, portable and dependable illumination
that can be used in a variety of settings. Featuring
a super-bright 120 LED lamp count, flicker-free
dimmable features and compatibility with multiple
battery types, the Genaray LED-5300 On-Camera Light
proves to be the perfect choice for photographers and
videographers alike.
LED-5300
INTRODUCTION
LED-5300 - USER MANUAL 3
· Lightweight Design With Powerful
120 Lamp Count
· Compact Profile & Case For Easy
Transport
· Removable Diffuser & 4300K
Warming Filter
· Integrated 1/4 20 Threaded
& Shoe Mounts
· 120 LED Light
· Slide-In Diffuser
· Slide-In 4300K Warming Filter
· NP-F550 Battery
· Battery Charger
· AC Adapter
· Sony AIS Adapter Mount
· Manual
KEY
FEATURES
PRODUCT
CONTENTS
FEATURES
LED-5300 - USER MANUAL
4
SAFETY
WARNINGS
· Do not attempt to disassemble,
repair or perform any unauthorized
modifications on this device
· Do not handle with wet hands,
immerse in liquids or expose to water
and rain; electric shock or fire may
result
· Device contains small parts which
may pose a choking hazard; keep out
of reach of children
· Do not operate device in presence of
flammable gas or vapors
· Do not use product if it emits smoke
or a strange odor and disconnect
power source immediately to avoid
personal injury and contact place of
purchase
· Observe caution when handling
batteries; only use batteries approved
by the manufacturer of this product
· Batteries are prone to leakage when
fully discharged; to avoid damaging
product be sure to remove batteries
when leaving product unattended
SAFETY WARNINGS
LED-5300 - USER MANUAL 5
· Do not intentionally stare or gaze at
LED light panel for prolonged periods
while device is on
· Do not cover the ventilation grille
found at the rear of device when in
operation and ensure light is cool
before storing
· Do not use or leave device in
conditions of extreme heat, severe
cold or high humidity
· Unit will display a decrease in
brightness when the battery runs
low; be sure to replace battery when
necessary to avoid affecting recording
quality
· When cleaning the device, use only a
mild detergent solution and quickly
wipe dry with a soft cloth
· Please dispose of used batteries,
packaging and old devices in
accordance with appropriate
environmental regulations
SAFETY WARNINGS
LED-5300 - USER MANUAL
6
Filter
Insertion
Slit
Locking
Ring
Optional Ball
Head Mount
(Sold Separately)
Cold Shoe Mount
Power &
Dimming
Wheel
1/4 20
Threaded Mount
PRODUCT
OVERVIEW
LED-5300 - USER MANUAL 7
Filter
Removal
Button
Power &
Dimming
Wheel
Battery
Mounting
Area
PRODUCT OVERVIEW
LED-5300 - USER MANUAL
8
MOUNTING LIGHT
UNIT DIRECTLY ON
CAMERA OR TRIPOD
POWERING
DEVICE USING
BATTERY
· Begin by holding a fully-charged battery in
position over mounting area, leaving only
a small gap between conductor contacts
found on battery and metal prongs found
on unit
· Push battery down and lock into place by
sliding it inward along grooves until an
audible click is heard
· Rotate power & dimming wheel upwards
into ON position to turn LED light on; adjust
wheel to achieve desired light intensity
· Battery can be removed by sliding it away
from metal conductor prongs found on unit
and lifting it upward
· Begin by positioning light directly over the
camera or tripod
· For cold shoe mounting, ensure that shoe
found on bottom of LED light unit is of
adequate height by adjusting locking ring
above shoe. Then slide entire shoe into
cold shoe of camera. Verify that locking
ring above shoe is properly tightened to
lock in place securely
· For tripod installation, simply insert 1/4 20
screw found on tripod head into the 1/4 20
threaded mount found on bottom of unit,
then tighten securely
INSTRUCTIONS
LED-5300 - USER MANUAL 9
POWERING
DEVICE USING
AC ADAPTER
· When finished, remove AC cord from
power outlet
· Battery adapter can be removed by sliding
it away from metal conductor prongs found
on unit and lifting it upward
· Begin by holding the battery-shaped end of
the AC adapter in position over mounting
area, leaving only a small gap between
conductor contacts found on holder and
metal prongs found on unit
· Push the AC adapter down and lock it into
place by sliding it inward along grooves
until an audible click is heard. Press firmly
to verify it is securely attached
· Plug the other end of the AC adapter into a
power outlet
INSTRUCTIONS
LED-5300 - USER MANUAL
10
· To adjust the flicker-free dimmable
feature, simply rotate the power &
dimming wheel until desired effect is
achieved
· To install the diffusion or warming filters,
slide a filter into filter insertion slit found
on side of LED light. Ensure that filter tab is
facing outward and push filter along groove
until it snaps into place
· To remove filter, push filter removal button
found on bottom of LED light unit and pull
filter tab outward to remove
INSTRUCTIONS
POWERING
DEVICE
LED-5300 - USER MANUAL 11
CUSTOMER
SUPPORT
· For more information about this
product or to contact the Genaray
Customer Support Center with any
questions, please send your email
correspondence to: info@genaray.com
Bulb Type: 120 Daylight LEDs
Brightness: 640 lux @ 3 ft.
Color Temperature: 5600K
Voltage: DC 6.0-9.0V
Weight: 5.2oz (147g)
Dimensions: 5×4.5×1.25 in. (12.7×11.43×3.2 cm)
SPECIFICATONS
PRODUCT
SPECIFICATIONS
GG3
ONE-YEAR LIMITED WARRANTY
This Genaray product is warranted to the original purchaser to be free from defects in materials and
workmanship under normal consumer use for a period of one (1) year from the original purchase date
or thirty (30) days after replacement, whichever occurs later. Genaray’s responsibility with respect
to this limited warranty shall be limited solely to repair or replacement, at Genaray’s discretion, of
any product that fails during normal use of this product in its intended manner and in its intended
environment. Inoperability of the product or part(s) shall be determined by Genaray. If the product
has been discontinued, Genaray reserves the right to replace it with a model of equivalent quality and
function.
This warranty does not cover damage or defect caused by misuse, neglect, accident, alteration, abuse,
improper installation or maintenance. EXCEPT AS PROVIDED HEREIN, GENARAY MAKES NEITHER
ANY EXPRESS WARRANTIES NOR ANY IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. This
warranty provides you with specific legal rights, and you may also have additional rights that vary from
state to state.
To obtain warranty coverage, contact the Genaray Customer Service Department to obtain a return
merchandise authorization (“RMA”) number, and return the defective product to Genaray along with
the RMA number and proof of purchase. Shipment of the defective product is at the purchaser’s own
risk and expense.
For more information, or to arrange service, visit www.genaray.com or contact us at info@genaray.com.
© 2018 Genaray. All Rights Reserved.
/
