Richmat HJH158 Ble Smart Home Remote Control User manual

Type
User manual
Product function
manual
Smart home
HJH158 Ble
一、Remote control button map
二.System configuration diagram
三、Remote control function description
Button
label
Function
1
Flashlight: Press the flashlight to turn on, release the
flashlight to turn off
2
ZG: Click to run to the zero gravity position, (FLAT+ZG)
memorize the current position zero gravity position
(there is an initial position, it will return to the
initial position after power failure), after the memory
is successful, the remote control backlight flashes, and
the buzzer sounds three times Voice.
3
M1: Click to run to the M1 position, (FLAT+M1) to memorize
the current position as the M1 position (no initial
position, the user-defined position after power
failure), after successful memory, the remote control
backlight flashes, and the buzzer sounds three times.
4
M2: Click to run to the M2 position, (FLAT+M2) to memorize
the current position as the M2 position (no initial
position, keep the custom position after power failure),
after the memory is successful, the remote control
backlight flashes, and the buzzer sounds three times.
5
Back up: Back up, release to stop
6
Back drop: back drop, release stop
7
FLAT: One key to run to the horizontal position, with
power-on reset function
8
Feet rise: feet rise, release to stop
9
Foot drop: foot drop, release to stop
Pairing method: [Remote head lift + foot lift (5,8) + control box
pairing key] The buzzer sounds, indicating that the pairing is
successful (The code key of the control box has a reset function).
Control box wired synchronization function: When two control boxes
are connected with a synchronization line, control one of the control
boxes, and the other control box is connected to the control box run
synchronously.
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Richmat HJH158 Ble Smart Home Remote Control User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI