2. Cumberland
  3. POWERTRAK

Cumberland POWERTRAK Owner's manual

  • I have reviewed the PowerTrak wiring harness user manual. This document provides a detailed guide for connecting a 9-conductor wire to a 3-wire controller, which includes wiring instructions for controlling the device itself. I'm ready to assist you with any questions you may have regarding the steps and wiring configurations mentioned in the manual.
  • What control wires should be used for Farm Hand Controls?
    Which wires provide power to the PowerTrak?
    What should be done after wiring the device?
4801-0153 PowerTrak 3 Wire Conversion PowerTrak
PowerTrak Wiring Harness
9 Conductor PowerTrak Connection to 3 Wire Controller
If you have a standard PowerTrak with a PCB-135A circuit board:
1. Disconnect the nine conductor wire, and limit switch and motor harness from the board.
2. Plug harness provided into motor, and limit switch harness.
3. Use Yellow(COM), Red(CLOSE), Brown(OPEN) control wires to go to Farm Hand Controls.
4. Use Green(GROUND), Black(HOT), White(Neutral) to supply 120V/240V power (depending on
model) to the PowerTrak.
5. Attach Label (Included) to inside of PowerTrak Door for future reference.
J3
12
11
10
9
8
7
6
5
1
2
3
4
J2
1
2
3
4
J1
9
8
7
6
5
4
3
2
1
J2
9
8
7
6
5
4
3
2
1
FAN-UPPER1
FAN-LOWER2
FAN-LOWER1
4 Pin from motor
12 Pin from limit switches
Blue
White
Black
Red
FAN-UPPER2
Plug harness into 12 pin limit
switch connector.
110vac White
Com Yellow
110vac Black
Close Red
Open Brown
Ground
Power to Unit 110VAC
Control Wires to Controller
9 Pin from controller
/