Getting Started
4
Chapter 2
Powering ON the projector
1. Connect the power cord to the SLC450.
2. Connect the other end of the power cord into the wall power source.
3. Press the switch on the back of the projector and the projector will turn on automatically
Standby Mode
1. To transition to “STANDBY” mode, press the power button on the remote control.
2. The optical engine should power off and the fan should stop spinning. The projector is now
in “STANDBY” mode and can be turned on using the remote control.
*Note: Standby mode will still consume a small amount of power.
Powering OFF the projector
1. To turn off the projector, press the
"Power Switch" twice. This will turn off
the projector completely.