2. BLOTZ
  3. B15-WF-102

BLOTZ B15-WF-102, B15-WF-107 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Post & Rail Fences B15-WF-102. This document provides guidance on assembling 15mm scale fences, including a gateway using PVA glue. It also mentions the use of a modelling knife and options to keep it hold during the drying process. I'm here to assist you with any questions you might have about the assembly process.
  • What kind of glue do I need?
    What tool is needed to remove sections from the sprue?
    What can I use to hold pieces together while the glue dries?
15mm Post & Rail Fences
B15-WF-102
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Post & Rail Fences (B15-WF-102)
For each fence remove one base and one set of rails
from the sprue.
Glue the rails to the base using the lugs/holes
provided (see above).
The gateway is formed from the pieces shown above.
Glue gateway to the base using the lugs/holes
provided (see above).
/