2. BLOTZ
  3. B10-CS-309

BLOTZ B10-CS-309 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ 10mm Octagonal Building Roof, model B10-CS-309. The document provides a detailed guide on how to assemble the components using glue and a modeling knife, also mentioning tips for clamping pieces while the glue is drying. I'm ready to answer any questions you have about the assembly process or the model itself.
  • What type of glue is needed?
    What can be used to clean the joints?
    What tool is needed to remove sections from the sprue?
10mm Octagonal Building Roof
B10-CS-309
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Remove one of the solid wall sections from the
sprue and a support.
Glue the support to the back of the wall section in the
lower set of holes as shown. Repeat this for the other
three solid wall sections.
Glue the roof into the upper holes on one of the
wall pieces.
Repeat this for the other three sections.
Then attach the window sections as shown.
Work round the building adding the wall coverings,
aligning them with the etched design. You may find
this easier if you put the roof section on top of the
middle / foyer sections.
The completed roof section.
/