Brodit 855019 Datasheet

Category
Holders
Type
Datasheet
29 January, 2015, www.brodit.com, © 2015 Brodit AB
Product 855019
855019 ProClip
Angled mount
The ProClip is a mounting bracket for the vehicle’s dashboard. Onto the ProClip you can install e.g. a holder for
your mobile phone or PDA or a handsfree set etc. Safe and convenient -always within easy reach. The ProClip is
car specific and easy to install. The installation is quick, no special tools or dismantle of the dashboard is required
and it will not damage the interior of the vehicle. Made in black ABS plastic. Comes with detailed instructions.
EAN: 7320288550190
Item no 855019 fits:
Infiniti Q60 14-15 (For USA)
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before installing the ProClip.
1. Press the thin end of the enclosed gap opener into the gap between the center console panel frame and the
console edge, to widen the gap. Peel off the cover of adhesive tape on the ProClip. Place the angled edge
towards the gap below the gap opener.
2. Press the angled edge all the way into the gap below the gap opener. Pull out the gap opener.
3. Push firmly forward on the right side of the ProClip face plate with your thumb so the angled edge flexes
forward and hooks into the gap in the console sidewall.
4. The ProClip is in place.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 855019 Datasheet

Category
Holders
Type
Datasheet

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI