LevelOne POS-1002-V2 Datasheet

LevelOne
Brand
LevelOne
Model
POS-1002-V2
Category
PoE adapters
Type
Datasheet

LevelOne POS-1002-V2 is a PoE (Power over Ethernet) Splitter that allows you to run Fast Ethernet speed PoE cables over long distances and then split the PoE signal into separate data and power sources. This means that you can network non-PoE devices without the need for a power outlet nearby. The device is compatible with Wireless Routers, Access Points, Network Cameras, Print Servers, Converters, and more. It also features an adjustable output DIP switch for 5V, 9V, and 12V adjustable output, interchangeable tips, and is light and compact.

LevelOne POS-1002-V2 is a PoE (Power over Ethernet) Splitter that allows you to run Fast Ethernet speed PoE cables over long distances and then split the PoE signal into separate data and power sources. This means that you can network non-PoE devices without the need for a power outlet nearby. The device is compatible with Wireless Routers, Access Points, Network Cameras, Print Servers, Converters, and more. It also features an adjustable output DIP switch for 5V, 9V, and 12V adjustable output, interchangeable tips, and is light and compact.

2
PoE Splitter
POS-1002
H/W Version: 2
The LevelOne POS-1002 PoE Splitter splits a networked
PoE signal into separate power and Fast Ethernet data
sources. This device allows administrators to run Fast
Ethernet speed PoE cables over long distances and
then split the PoE signal into separate data and power
sources in order to network non-PoE devices. This
active PoE splitter is available in the following output
voltages (5V or 9V OR 12V).
Save installation and equipment cost when installing
access points, IP cameras and more in remote
locations With no need to install network devices
near a power outlet. This compact device safeguards
valuable network equipment with short circuit
protection and quickly creates an integrated PoE and
non PoE network at Fast Ethernet speeds.
Key Features
- Converts non-PoE devices with Power over Ethernet
support
- Adjustable output DIP switch for 5V, 9V, and 12V
adjustable output
- Delivering power and data to equipment via a single
Ethernet cable
- Eliminates the need for a bulky power adapter and
power line for your appliance
- Compatible with Wireless Router, AP, Network
Camera, Print server, Converter
- Light weight and compact size
- Provides interchangeable tips
Works Well With
POI-2002
PoE Injector
1. LED Indicators
2. Adjstable DIP Switch
3. RJ-45 Port (Power + Data)
4. Interchageable tips (Power out)
5. RJ-45 Connector
6. Wall-Mountable
5
POI-2001
Gigabit Injector
43
1 2
6
4 4 4 4
3
PoE PD/PSE/Repeaters
www.level1.com
I
one world_one brand_one level_
Standards Compliance
IEEE 802.3 10Base-T
IEEE 802.3u 100Base-Tx
IEEE 802.3af Power over Ethernet
Data Rate:
RJ-45, 10/100 Mbps
Input Power Requirement
Pin Assignment and Polarity: 1/2(+), 3/6 (-) or 4/5(+), 7/8(-)
Output Power Voltage
5V (2A), 9V (1.1A), 12V (1A)
Dimensions: (L x W x H) / Weight
80 x 55 x 31mm /81g
Technical Specication
Diagnostic LEDs
DC Power (Green)
Environmental Conditions
Operating Temperature: 0~45°C
Storage Temperature:95%, Non-condesing
Regulatory
RoHS Compliant, CE/FCC
Safety Approvals
CE, FCC, EN 60950:2006
Product Diagram
Order Information POS-1002: PoE Splitter
Package Contents
POS-1002 x 1
Quick Installation Guide x 1
All mentioned brand names are registered trademarks and property of their owners. Technical specications are subject to change without notice.
© Copyright Digital Data Communications GmbH. All Rights Reserved.
V2.0
Non-PoE Switch
Non-PoE Device
POS-1002
Power
Ethernet (RJ 45)
PoE
Others
PoE Injector
(POI-2002)
Data
  • Page 1 1
  • Page 2 2

LevelOne POS-1002-V2 Datasheet

LevelOne
Brand
LevelOne
Model
POS-1002-V2
Category
PoE adapters
Type
Datasheet

LevelOne POS-1002-V2 is a PoE (Power over Ethernet) Splitter that allows you to run Fast Ethernet speed PoE cables over long distances and then split the PoE signal into separate data and power sources. This means that you can network non-PoE devices without the need for a power outlet nearby. The device is compatible with Wireless Routers, Access Points, Network Cameras, Print Servers, Converters, and more. It also features an adjustable output DIP switch for 5V, 9V, and 12V adjustable output, interchangeable tips, and is light and compact.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents