Homelite ut40530 Owner's manual

Homelite
Brand
Homelite
Model
ut40530
Type
Owner's manual

This manual is also suitable for

Homelite UT40530 is a powerful and versatile water pump designed to handle a wide range of pumping tasks. With its robust construction and reliable performance, it is ideal for both residential and commercial applications.

The UT40530 is powered by a 4-cycle engine that delivers excellent fuel efficiency and low emissions. It features a self-priming design that allows for quick and easy setup, even in challenging conditions. The pump is equipped with a durable cast iron impeller and volute that provide exceptional durability and resistance to wear.

One of the key advantages of the UT40530 is its versatility. It can be used for a variety of tasks, including:

Homelite UT40530 is a powerful and versatile water pump designed to handle a wide range of pumping tasks. With its robust construction and reliable performance, it is ideal for both residential and commercial applications.

The UT40530 is powered by a 4-cycle engine that delivers excellent fuel efficiency and low emissions. It features a self-priming design that allows for quick and easy setup, even in challenging conditions. The pump is equipped with a durable cast iron impeller and volute that provide exceptional durability and resistance to wear.

One of the key advantages of the UT40530 is its versatility. It can be used for a variety of tasks, including:

991000545
6-12-15 (REV:01)
Add entire bottle of lubricant provided to the unit
(see page 12).
WARNING:
This Quick Reference Guide is not a substitute for reading the operator’s manual. To reduce the risk of injury or death, user must read and understand operator’s manual before using this product. All page references refer to
the operator’s manual.
FIRST TIME ASSEMBLY
UT40530 QUICK REFERENCE GUIDE
STARTING THE UNIT
USING THE WATER PUMP
STORING THE UNIT
1 4
3
5
2
Attach suction hose (not included) to strainer using
a hose clamp (see page 10).
Connect suction hose (not included) to water source
(see page 11).
Attach discharge hose (not included) to pump outlet
(see page 11).
Attach suction hose (not included) to pump inlet
(see page 10).
Add fuel (see page 12).
1
2
Prime the water pump. (See page 13).
Move the fuel lever to CLOSED before adding
lubricant.
Set unit on flat surface so engine is level.
Remove dipstick, wipe clean, put back in hole
(but don’t screw in) and check luricant level.
This is a 4-cycle engine. Do not mix fuel and
lubricant together.
Mix fuel stabilizer with gasoline according to
manufacturer’s directions prior to filling the
tank.
STOPPING THE UNIT
Put the engine switch in the OFF position (see page 13).
1
Follow all instructions and rules when using the water pump (see pages 3 - 5).
• Do not start or operate the engine in a confined space, building, near open windows, or in other unventilated
space where dangerous carbon monoxide fumes can collect.
• Do not use this product to pump acids, alkalines, solvents, flammable material, bleaches, or industrial grade
solutions.
• Secure the pump to reduce the risk of injury or property damage due to unexpected tool movement. If any
tipping or walking is noticed, stop operation and anchor the pump to prevent movement.
• Do not operate the pump unless a filtered suction hose is attached and connected to a water source.
• Secure the discharge hose. An unsecured hose may whip or “kick back” during operation and cause serious
personal injury.
• For maximum suction, keep the distance from the pump and water source as short as possible.
• Avoid running the tool at low or high speeds for extended periods of time as this may damage the pump.
When preparing to store the water pump, allow the unit to cool for five muntes, then follow the guidelines listed
on page 15 and 16.
1
1
TROUBLESHOOTING
IMPORTANT!
Only use OUTSIDE and
far away from windows,
doors, and vents.
NEVER use inside a home
or garage, EVEN IF doors
and windows are open.
Using a gas water pump indoors CAN KILL YOU IN MINUTES. Engine exhaust
contains carbon monoxide. This is a poison you cannot see or smell. Use
sufficient hose length to keep pump at least 20 feet (6 meters) away from
all windows, doors, and vents. Direct engine exhaust away from all
windows, doors, and vents.
Move throttle lever to the RIGHT (see page 13).
Move the choke to the START position (see page 13).
Move the fuel lever to the OPEN position (see page 13).
Put the engine switch in the ON position
(see page 13).
Pull the starter grip and rope until the engine runs
(see page 13).
3
4
5
6
7
NOTICE:
Do not use E15
or E85 fuel in
this product. It is a violation of federal
law and will damage the unit and void
your warranty. Only use unleaded gaso-
line containing up to 10% ethanol.
ENGINE SWITCH
(OFF POSITION)
ENGINE SWITCH
(ON POSITION)
PULL
STARTER GRIP
AND ROPE TO
START
THROTTLE LEVER (FULLY RIGHT)
CHOKE (START POSITION)
FUEL LEVER (OPEN POSITION)
NOTICE:
Always observe all local regulations
when discharging pumped water.
Some areas have restrictions against
discharging pumped water. Check with
the appropriate authorities before using
this water pump.
PROBLEM CAUSE SOLUTION
Engine will not start No fuel in tank
Spark plug shorted or fouled
Spark plug is broken (cracked porcelain or
electrodes broken)
Ignition lead wire shorted, broken, or discon-
nected from spark plug
Ignition inoperative
Choke lever is in RUN position
Fill tank
Replace spark plug
Replace spark plug
Replace lead wire or attach to spark plug
Contact qualified service center.
Move choke lever to START position.
Engine hard to start Water in gasoline
Weak spark at spark plug
Drain entire system and refill with fresh fuel.
Contact qualified service center
Engine lacks power Dirty air filter Clean or replace air filter
Output lower than normal Connections leaking
Throttle lever pushed to the right
Suction hose damaged or leaking
Discharge hose damaged or leaking
Tighten connections
Push throttle lever to the left
Replace suction hose
Replace discharge hose
If problem persists after trying the above solutions, contact customer service or a qualified service center for assistance.
NOTICE:
As the equipment owner, you are responsible for the performance of the required maintenance listed in the Maintenance
section It is recommended that you retain all receipts covering maintenance on your equipment. Neglecting or failing to
perform the required maintenance may increase emissions, decrease fuel efficiency, degrade performance, cause irreversible
engine damage and/or void your warranty.
Make the most of your purchase! Go to www.homelite.com and
register your new tool online. For questions about operating
or maintaining your product, please call, 1-800-242-4672.
  • Page 1 1

Homelite ut40530 Owner's manual

Homelite
Brand
Homelite
Model
ut40530
Type
Owner's manual
This manual is also suitable for

Homelite UT40530 is a powerful and versatile water pump designed to handle a wide range of pumping tasks. With its robust construction and reliable performance, it is ideal for both residential and commercial applications.

The UT40530 is powered by a 4-cycle engine that delivers excellent fuel efficiency and low emissions. It features a self-priming design that allows for quick and easy setup, even in challenging conditions. The pump is equipped with a durable cast iron impeller and volute that provide exceptional durability and resistance to wear.

One of the key advantages of the UT40530 is its versatility. It can be used for a variety of tasks, including:

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents