Meyer Sound Leopard Installation guide

Meyer Sound
Brand
Meyer Sound
Model
Leopard
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
LINE ARRAY/LF
LEOPARD/900-LFC Collapsible Rain Hood Attachment
PARTS L IST
The Collapsible LEOPARD/900-LFC Rain Hood Kit includes the following parts:
• LEOPARD/900-LFC Collapsible Rain Hood Assembly (PN 45.243.215.01)
• 2 pan head Phillips 6-32 x 0.75-inch stainless-steel screws (PN 101.269)
LEOPARD COLLAPSIBLE RAIN HOOD ATTACHMENT
The LEOPARD/900-LFC collapsible rain hood (Figure 1) is easily attached and removed with its two screws. (Illustration
shows only the LEOPARD loudspeaker, but the steps are the same for the 900-LFC subwoofer.)
To attach the LEOPARD/900-LFC collapsible rain hood:
1. Slip the rain hood under the rain hood retainer flange at the top of the user panel.
2. Secure the rain hood at the bottom of the panel with the two provided 6-32 x 0.75-inch stainless steel screws.
3. Make sure to tighten the screws to create a good seal against the user panel. The recommended torque value for rain
hood screws is 10–12 in-lbs (1.1-1.4 N·m).
To use the LEOPARD/900-LFC collapsible rain hood:
1. Detach the Velcro straps and extend the rain hood.
2. Extend the lower flap for splash protection.
Figure 1: LEOPARD with Collapsible Rain Hood
Rain Hood
Retainer Flange
Meyer Sound Laboratories Inc.
2832 San Pablo Avenue
Berkeley, CA 94702
+1 510 486.1166
www.meyersound.com
© 2019
Meyer Sound. All rights reserved.
LEOPARD/900-LFC Collapsible Rain Hood Attachment
PN 05.243.215.01 A
LEOPARD/900-LFC COLLAPSIBLE RAIN HOOD INSTALLATION INSTRUCTIONS
3. Attach any required cables to the LEOPARD/900-LFC.
The clear windows make it easy to locate the connectors on the user panel.
4. To stow the rain hood, reverse the steps.
CAUTION: There is only one proper loudspeaker orientation once the rain hood is installed. The loudspeaker
must be oriented so that all cabling exits from the bottom of the rain hood.
CAUTION: The weather-protected LEOPARD/900-LFC loudspeaker must be mounted with a 0
° tilt, or
preferably with a slight down-tilt. This angle shields the driver from the elements and does not allow water to
accumulate. Do not tilt the cabinet up, as the drivers and cabinet will accumulate water.
!
!
  • Page 1 1
  • Page 2 2

Meyer Sound Leopard Installation guide

Meyer Sound
Brand
Meyer Sound
Model
Leopard
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents