Reely 1406780 Operating instructions

Motor-Sound-Simulator

Item No. 1406780

Intended Use

The product is used to generate motor sounds in electrically operated model vehicles. The

voltage/power supply takes place via an interim plug directly from the vehicle's drive battery.

The safety notes and all other information in these operating instructions always have to be

observed.

This product complies with the statutory national and European requirements. All company

Scope of Delivery

• Motorsoundsimulator

• CablewithTamiyainterimplugandBECconnection

• 2adhesivepads

• OperatingInstructions

Current operating instructions:

 1.Openwww.conrad.com/downloadsinabrowserorscan

the QR-code shown on the right.

 2.Selectthedocumenttypeandlanguage,andthenenter

thecorrespondingordernumberinthesearcheld.After

searchingstarts,youcandownloadthedocumentsfound.

Safety Information

In case of damage caused by non-compliance with these operating instruc-

tions, the warranty/guarantee will expire. We do not assume any liability for

consequential damage!

We do not assume any liability for property damage and personal injury caused

by improper use or non-compliance with the safety instructions. In such cases

the guarantee/warranty will expire!

• Theunauthorizedconversionand/ormodicationoftheproductisprohibitedforsafetyand

approvalreasons(CE).

• Thisproductisnotatoyandmustbekeptoutofthereachofchildren!

• Theproductmustnotbecomedamporwet.

• Too-highvolumesmaycausedamagetothehearingofhumansandanimals.Keepsufcient

distance from the speaker when testing and in operation.

• Donotleavethepackagingmateriallyingaroundcarelesslyasitcanbecomeadangerous

toy for children.

• Ifyouhavequestionswhichremainunansweredintheseoperatinginstructions,pleasecon-

tact us or another expert.

Installation

The motor sound simulator must be installed in the vehicle so that it will remain safely in place

whendriving.Thehousingcanbeattached,e.g.withdouble-sidedadhesivetapeorcableties.

Observetheexampleinstallationinthefollowinggure.

Wheninstalling,ensurethattheopeningsofthespeakerarenotcovered.Ensuresufcient

cooling,sincetheelectronicswillheatupathighervolumes.

1 Motorsoundsimulator

2 BECsocket

3 Tamiyasocket(connecttothespeedcontroller)

4 Tamiyaplug(connecttothedrivebattery)

5 Servoplugforconnectiontothereceiver

6 Servoconnectionsocketforcontrolcabletothespeedcontroller

7 BECplug

8 Volume button

Connection

Forpowersupplyofthemotorsoundsimulator,atwo-polecablewithBECconnection(2)is

routedoutofthehousing.ConnectthisconnectiontotheBECplug(7)oftheenclosedinterim

plug cable.

Connectthehigh-currentconnectionofthespeedcontrollertotheTamiyasocket(3)ofthe

interim plug cable.

The servo-Y-cable of the motor sound simulator is connected to the control cable of the speed

controlleraswellastheassociatedreceiveroutput.Theplug(5)belongsinthereceiver.The

speedcontrollerisconnectedtothesocket(6).Ensurecorrectpolarityoftheplugsforthis.

Theservoplug(5)isconnectedtothechannelofthereceivertowhichthespeedcontroller

was previously connected.

Last,thedrivebatteryisconnectedtotheTamiyaplug(4).

Functional Description

Themotorsoundsimulatorisconnecteddirectlytothereceiveroutput,whichisalsousedfor

thespeedcontroller,viaaYcable.Themotorsoundisputoutaccordingtothethrottleposition

for the speed controller.

Thisway,themotorsoundisputoutaccordingly,sothatstarter,idleoraccelerationandfull

throttle sounds are possible.

The motor sound simulation starts when you tap the lever for the motor control (throttle/brake

lever)ofyourtransmitterbriey(intheforwarddrivingdirection).

The button "+" increases the volume step by step. The button "-" reduces the volume step by

step.Inthelowestsetting,theinstalledspeakerisswitchedoff.

The motor sound simulator is supplied with power from the drive battery used via an interim

plug due to the required power intake.

Version 01/16

Operating instructions

www.conrad.com

Programming the neutral position and full throttle position

Forthemotorsoundtobeproperlyoutput,theneutralpositionandthefullthrottlepositionsfor

forward and reverse driving can be programmed at the motor sound simulator.

Attention!

 Whenprogramming,transmittermustbemovedtothefullthrottlepositionsforfor-

ward and reverse driving respectively.

 Toavoidaccidentsorinjury,themodelmustthereforebeputonsuitablegroundso

thatthewheelscanspinfreely.Holdthemodelorfastenitsuitably.Donotreachinto

thedrive,however!

 For reasons of safety, we recommend disconnecting the motor from the speed

controller(rememberthealignmentoftheplugs).Withthemotordisconnected,the

sound signals of the motor sound simulator can also be heard better during program-

ming.

Proceed as follows for programming:

• Switchonthetransmitter.Thenconnectthedrivebatterytothevehicle.Switchonthespeed

controller. The vehicle should now react to the control signals of the transmitter (speed con-

troller/steeringservo).

• Keepthebutton"+"atthemotorsoundsimulatorpushedformorethan1seconduntilthemo-

tor sound simulator emits a beep. The motor sound simulator is now in programming mode.

Release the button "+" again.

• Ensurethattheleverforthemotorcontrolfunctionatthetransmitterisintheneutralposition

(releasethelever,donotmoveit).

 Conrmthissettingbypushingthebutton"+"atthemotorsoundsimulatorbriey.Themotor

sound simulator emits a beep. The neutral position is now saved.

• Movetheleverforthemotorcontroltothefullthrottlepositionfordrivingforwardandholdit

in this position.

 Conrmthissettingbypushingthebutton"+"brieyoncemore.Themotorsoundsimulator

emits a beep.

• Movetheleverforthemotorcontroltothefullthrottlepositionforreversingandholditinthis

position.

 Conrmthissettingbypushingthebutton"+"briey.Thesoundsimulatoremitsabeep.

• Theprogrammingisconrmedbyalongbeep.

• Puttheleverforthemotorcontrolbacktotheneutralposition(releasethelever).Program-

ming is complete.

 Ifthesoundsimulatorbeepsseveraltimes,theelectronicsystemhasnotrecognised

thesetting.Inthatcase,repeattheaboveprogrammingprocess.

The programming can be cancelled if you keep the button "-" pushed for a longer

durationduringprogramming.Thisissignalledbyalongbeep.Programmingmode

is completed.

• Ifthemotorhasbeendisconnectedforprogramming,switchoffthespeedcontrollerrst.

Thenconnectthemotortothespeedcontroller(ensureproperassignmentoftheplugs).

Checking the function of the motor sound simulator

• Afterswitchingonthespeedcontroller,nomotorsoundofthemotorsoundsimulatorcanbe

heard.Onlywhenyoutapthethrottle/brakeleverintheforwarddrivingdirectionalittlewilla

startersoundappear,followedbyanidlesound.

• Whenmovingthethrottle/brakeleveratthetransmitterintheforwarddrivingdirection,the

motor sound will correspond to that of an accelerating vehicle.

• Ifyoumovethethrottle-brakeleveratthetransmitterinthereversingdirection,aslightly

changedmotorsoundwillbeoutput(asinaregularcar).

• Ifapplicable,usethebutton"+"or"-"toadjustvolume.

 Ifthemotorsounddeviatesfromtheabovedescription,re-programme.

 Ifthemotorsoundsimulatorbeepsseveraltimes,theelectronicsystemhasnotrec-

ognised the setting. Repeat programming in that case.

Disposal

a) General Information

The product does not belong in the household waste.

 Disposeoftheproductaccordingtotheapplicablestatutoryprovisionsattheendof

its service life.

b) Batteries and Rechargeable Batteries

Youastheenduserarerequiredbylaw(BatteryOrdinance)toreturnallusedbatteries/re-

chargeablebatteries.Disposingoftheminthehouseholdwasteisprohibited!

 Batteriesandrechargeablebatteriescontaininghazardoussubstancesaremarked

with the adjacent symbol to indicate that disposal in the household waste is prohibit-

ed.Thedescriptionsfortherespectiveheavymetalsare:Cd=cadmium,Hg=mercury,

Pb=lead(thenamesareindicatedonthebattery/rechargeablebatterye.g.belowthe

rubbishbinsymbolshowntotheleft).

Youmayreturnusedbatteries/rechargeablebatteriesfreeofchargeattheofcialcollection

pointsinyourcommunity,inourstores,orwhereverbatteries/rechargeablebatteriesaresold.

Youthusfullyourstatutoryobligationsandcontributetotheprotectionoftheenvironment.

Technical Data

Operatingvoltage .................................5.0V/DCto8.4V/DC(2-cellLiPodrivebatteryor6-cell

NiMHdrivebattery)

Powerconsumption ..............................Max.approx.1A

Speakerimpedance ..............................4Ohm

Output ................................................... Max.6W(with2-cellLiPodrivebatteryat8V)

Servoplugsystem ................................Futaba build

Rechargeable battery plug system .......Tamiya build

Dimensions(LxWxH) ........................90x39x28mm

Weight ..................................................Approx. 60 g

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).

All rights including translation reserved. Reproduction by any method, e.g. photocopy, microlming, or the capture in

electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.

This publication represent the technical status at the time of printing.

Reely 1406780 Operating instructions

Related papers

Other documents