Cylinder Removal and Re-Keying Kit
Part Kit Reorder
Number Description Qty. Qty.
F605-367 CYLINDER DRIVER BAR FOR KPL 10 100
B520-628 WASHER FOR KPD TAILPIECE 15 150
B520-607 SPACER FOR KPD TAILPIECE 15 150
B520-608 RETAINER FOR KPD TAILPIECE 25 250
F605-349 SCREW FOR ATTACHING OUTSIDE KPD 15 150
ESCUTCHEON TO BASEPLATE
B520-606 CYLINDER DRIVER BAR FOR KPD 10 100
Schlage Keypad Deadbolts come standard with a 5-pin solid
brass C-keyway cylinder. The re-keying steps are the same as
for the Schlage B-300 series deadbolt. Cylinder removal and
replacement instructions are illustrated on the back page.
A supplemental kit has been designed with replacement
parts for the Keypad Locks and Deadbolts.
Supplemental Re-Keying Kit
Part Number 38-030 Keypad Re-Keying Kit
1
5
Rekey Cylinder as Usual
BE365 Cylinder Removal Instructions
2
NOTE: Tailpiece is available in the Schlage Supplemental
Electronics Lock Rekeying Kit
9
Use BE365 Installation Sheet to Install Lock.
Reinstall Cylinder as Shown
NOTE: Make sure top of cylinder is pointing toward keypad.
Top of Cylinder
Keypad
Remove Backplate from Outside Keypad Assembly
Remove Cylinder from Thumbturn
8
3
Remove Retainer, Block and Disc from Cylinder
7
Install Disc, Block and Retainer
6
Install Spring, Pin, Tailpiece, and Cylinder Cap
4
Remove Cylinder Cap, Tailpiece, Pin, and Spring
© 2006 Ingersoll Rand Company Limited MR-1602
-
1
-
2
Ingersoll-Rand BE365 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Global Door Controls GLC560UL-IC626 Installation guide
-
Schlage 70A User manual
-
-
Sargent A7476D Operating instructions
-
-
-
Schlage FE595 User manual
-
-
Master Lock MLKSLCHSR26D Installation guide
-