Electrolux DAGL6030CN Installation guide

DAGL6030CN
Electrolux
Brand
Electrolux
Model
DAGL6030CN
Type
Installation guide
Installation manual
Activated carbon filter
AKF LL 45-14
56334 01/12
1
2
3
4
2
Installation instructions activated carbon filter
Set 893 574 100 regeneratable long-life filter (AKF LL45-14) for
DA GL 55
DA GL 60
DA SL 55
DA SL 60
DA SL 82
DA SL 90
comprised of:
1x Activated carbon filter
3
1x Instruction and installation manual
1x Reminder sticker
4
no. 56331 ( In the case of DA SL 55, DA SL 60, DA SL 82,
DA SL 90, it is not necessary, as there is an electronic reminder. )
Installation
1. Pull out the extending hood
1
( the fan is running! )
2. Lift up the metal filters
2
at the rear and slot them in place at the front.
2
a
a
b
b
3
Indicator light
Activated charcoal filter
3. Push the activated carbon filter
3
into the brackets in the direction of the arrow
a
than fold up at the front
b
and push up both sides, left and right, until both latches
snap in place.
4. Insert metal filter
2
.
Important: Activation of the monitoring function
In recirculating mode and when an activated
carbon filter is fitted, it is advisable to enable
the monitor function for the activated carbon
filter. To enable this function, press and hold
button 2 for 10 seconds, until indicator light
C comes on.
Operating instructions
The activated carbon filter must be regenerated before using the appliance for the first
time, as every activated carbon filter absorbs moisture. The moisture must be extracted.
Lay the filter cassette flat on the oven shelf in the middle of your oven and heat it up
for an hour at 230 °C. Then allow the filter to cool down completely for two hours!
If the filter is inserted to soon the extractor hood may be damaged as a result of the residual
heat of the carbon. The regeneration process may result in a normal discoloration of the
filter. The filter can then be placed in the extractor hood again. Your appliance is now ready
for use.
Regeneration
Moisture and grease particles reduce the absorbent capacity of the activated carbon, so it
must be regenerated after 2 months at the latest.
Lay the filter cassette flat on the oven shelf in the middle of your oven and heat it up
for an hour at 230 °C. Then allow the filter to cool down completely for two hours!
The filter can then be placed in the extractor hood again. Your appliance is now ready for
another 2 months use. A sticker marked in red is included in the set as a reminder to do the
regeneration. (Tip: Stick it to the inside of the herbs and spices cupboard door, don‘t stick
it on the extractor hood.)
The filter loses its effectiveness after approx. 4 years, and should then be completely repla-
ced (it is not possible to refill the activated carbon).
Electrolux AG, 8048 Zürich, Tel. 044/405‘81‘11
Regeneratable activated carbon filter AKF LL 45-14
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Electrolux DAGL6030CN Installation guide

DAGL6030CN
Electrolux
Brand
Electrolux
Model
DAGL6030CN
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents