Electrolux AKFLL4520 User manual

Brand: Electrolux

Model: AKFLL4520

Type: User manual

Electrolux AKFLL4520 is a regeneratable long-life activated carbon filter compatible with Electrolux cooker hoods. It efficiently absorbs odors and grease particles, ensuring a fresh and clean kitchen environment. The filter can be easily installed and removed for regeneration, which involves heating it in an oven at 230°C for an hour. Regular regeneration (every two months) extends the filter's lifespan up to four years.

Electrolux AKFLL4520 is a regeneratable long-life activated carbon filter compatible with Electrolux cooker hoods. It efficiently absorbs odors and grease particles, ensuring a fresh and clean kitchen environment. The filter can be easily installed and removed for regeneration, which involves heating it in an oven at 230°C for an hour. Regular regeneration (every two months) extends the filter's lifespan up to four years.

Installation manual

Activated carbon ﬁlter

AKF LL 45-20

56420 02.19

1

2

3

4

2

Installation instructions activated carbon ﬁlter

Set 902 980 068 regeneratable long-life ﬁlter (AKF LL45-20) for

DA GL 55

DA GL 60

DA SL 55

DA SL 60

DA SL 82

DA SL 90

comprised of:

1x Activated carbon ﬁlter

3

1x Instruction and installation manual

1x Reminder sticker

4

no. 56331 ( In the case of DA SL 55, DA SL 60, DA SL 82,

DA SL 90, it is not necessary, as there is an electronic reminder. )

Installation

1. Pull out the extending hood

1

( the fan is running! )

2. Lift up the metal ﬁlters

2

at the rear and slot them in place at the front.

2

Indicator light

Activated charcoal ﬁlter

a

a

b

b

3

3. Push the activated carbon ﬁlter

3

into the brackets in the direction of the arrow

a

than fold up at the front

b

and push up both sides, left and right, until both latches

snap in place.

4. Insert metal ﬁlter

2

.

Important: Activation of the monitoring function

For devices with touch control:

In recirculating mode and when an activated carbon ﬁlter is ﬁtted, it is advisable to enable the

monitor function for the activated carbon ﬁlter. To enable this function, press and hold button

1 and 3 for 10 seconds, until indicator light C comes on.

For older devices with ﬁlm keypad:

In recirculating mode and when an activated carbon ﬁlter is ﬁtted, it is advisable to enable

the monitor function for the activated carbon ﬁlter. To enable this function, press and hold

button 2 for 10 seconds, until indicator light C comes on.

Operating instructions

The activated carbon ﬁlter must be regenerated before using the appliance for the ﬁrst

time, as every activated carbon ﬁlter absorbs moisture. The moisture must be extracted.

Lay the ﬁlter cassette ﬂat on the oven shelf in the middle of your oven and heat it up

for an hour at 230 °C. Then allow the ﬁlter to cool down completely for two hours!

If the ﬁlter is inserted to soon the extractor hood may be damaged as a result of the residual

heat of the carbon. The regeneration process may result in a normal discoloration of the

ﬁlter. The ﬁlter can then be placed in the extractor hood again. Your appliance is now ready

for use.

Regeneration

Moisture and grease particles reduce the absorbent capacity of the activated carbon, so it

must be regenerated after 2 months at the latest.

Lay the ﬁlter cassette ﬂat on the oven shelf in the middle of your oven and heat it up

for an hour at 230 °C. Then allow the ﬁlter to cool down completely for two hours!

The ﬁlter can then be placed in the extractor hood again. Your appliance is now ready for

another 2 months use. A sticker marked in red is included in the set as a reminder to do the

regeneration. (Tip: Stick it to the inside of the herbs and spices cupboard door, don‘t stick

it on the extractor hood.)

The ﬁlter loses its effectiveness after approx. 4 years, and should then be completely repla-

ced (it is not possible to reﬁll the activated carbon).

Electrolux AG, 8048 Zürich, Tel. 044/405‘81‘11

Regeneratable activated carbon ﬁlter AKF LL 45-20

1
2
3
4

Electrolux AKFLL4520 User manual

Brand: Electrolux

Model: AKFLL4520

Type: User manual

Electrolux AKFLL4520 is a regeneratable long-life activated carbon filter compatible with Electrolux cooker hoods. It efficiently absorbs odors and grease particles, ensuring a fresh and clean kitchen environment. The filter can be easily installed and removed for regeneration, which involves heating it in an oven at 230°C for an hour. Regular regeneration (every two months) extends the filter's lifespan up to four years.

Download PDF

Related papers

Other documents