Hampton Bay 5LGZ1291-V3 Installation guide

Brand
Hampton Bay
Model
5LGZ1291-V3
Type
Installation guide

This manual is also suitable for

GARDEN HOUSE 10FT X10FT
USE AND CARE GUIDE
garden house.
THANK YOU
1-855-HD-HAMPTON
HAMPTONBAY.COM
to continually create quality products designed to enhance your home. Visit us online to see our full line of products available
for your home improvement needs. Thank you for choosing Hampton Bay!
Questions, problems, missing parts? Before returning to the store,
call Hampton Bay Customer Service
8.00 a.m. - 7.00 p.m. EST, Monday - Friday,
9.00 a.m. - 6.00 p.m. EST, Saturday
Model # 5LGZ1291-V3
2
Table of Contents
Safety Information
Table of Contents ........................................................2
Safety Information .......................................................2
Pre-Assembly ............................................................3
Planning Assembly...................................................................3
Part List....................................................................................3
Assembly .......................................................................4
Care Instructions....................................................................2
WARNING:
of any foreign
WARNING: This garden house Gazebo is NOT a permanent structure and is designed for sunshade and privacy and must be used under
normal weather conditions. We recommend removal of the fabric canopy in windy conditions as gazebos catch wind similar to umbrellas. You
must however completely disassemble the unit prior to any severe weather conditions such as thunderstorm, hurricane, and/or heavy wind and
rain. Failure to remove the fabric canopy or disassemble the unit will cause the gazebo to have structure damage or even structural collapse.
CAUTION: Always install on level ground utilizing tie down cords and ground stakes. Do not permanently anchor unit to wood deck or
CAUTION: Garden house fabrics are water resistant but not water proof and may leak during precipitation. Fabrics will fade from direct
exposure to sunlight.
CAUTION: Keep all children and pets away from assembly area.
Begin assembly not less than 6 feet from any obstruction such as fence, garage, house, overhanging branches, clothes line or electrical wires.
Some parts may contain sharp edges, wear protective gloves if necessary. At least two or more people are recommended for safe assembly.
concrete surface.
Care Instructions
Before using, wipe with a clean, dry cloth. Do not use bleach or solvents. Treat the frame with liquid wax for maximum protection against
UV light and salty, damp air. Wash the canopy with a mild solution of soap and water, rinse thoroughly, air dry completely.
Please properly tighten all hardware and perform periodic inspections during usage for cracked welds or loose nuts or bolts.
You may contact our customer service department with any questions by phone at 1-855-HD-HAMPTON or visit www.hamptonbay.com.
3
Pre-Assembly
PLANNING ASSEMBLY
It will take at least two people about 20 minutes to complete the assembly process.
Part Description Quantity
Ground stake
M 44
Bolt cap
N 1
Main canopy
O
4
Reinforcement bar
P
1
Q
Hex wrench
Corner roof tube (short)
8
1
4
R
S
A Philips screw driver, a rubber mallet and a free standing ladder are needed during the process.
U
Plastic ring
Netting panels
40
4
T
U
Tie-down cord
Plastic anchor
V
W
4
4
Part Description Quantity
A
4
PART LIST
B
C 4
Left cross beam
D 4
Right cross beam
E 4
Corner roof tube (long)
F 4
Middle roof tube
Corner panel
4
Corner panel
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
G
1
Roof hub
H 4
Corner bracket
R
I 36
Bolt (M6x32)
S
T
J 8
Bolt (M6x16)
K 8
Screw (5x16)
L
24
Nut
V
W
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Wrench
4
Assembly
Assemble the corner panels
Attach one corner panel (A) to each corner panel (B) to form a complete corner panel
with bolts (I) and nuts (L) using wrenches (P) and (R). (Fig. 1)
Assemble the cross beams
Snap one cross beam (C) into each cross beam (D) and secure them with bolts (J) using hex wrench (R). (Fig.2)
Fig. 2
Important: Corner panel (A) must stay on the outside left side of the corner panel (B).
C
D
C
D
J J
□
□
Fig. 1
P
R
8
4
8
P
R
88
R
J
1
2
12
5
Assembly
Erecting the main frame
3
□
Attach the (C) side of the assembled cross beam to the corner bracket (H) at the top of the (B) side of the corner panels
□
Attach the (D) side of the complete cross beam to to the corner bracket (H) at the top of the (A) side of the corner panels
□
Repeat this until the main frame is set up.
(Fig.3.2)
with bolt (I) and nut (L) using wrenches (P) and (R). (Fig.3.3
with bolt (I) and nut (L) using wrenches (P) and (R). (Fig.3.3)
A
B
A
B
B
A
H
L
I
L
I
I
O
I
I
Attach the corner bracket (H) onto the top of panel (B) in the corner with bolt (I) and nut (L) using wrenches (P) and (R).
C
D
□
Fig.3.1 Fig.3.2
Fig.3.3 Fig.3.4
Attach the reiforcement bar (O) onto (C) and (D) in the corner with bolts (I) using wrench (R) Fig.3.4)
□
C
D
C
C
C
D
D
D
O
O
O
O
A
B
D
C
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
P
R
20
Assembly (continued)
Assembling the roof frame
4
6
E
E
S
S
E E
EE
F F
F
F
L
K
K
K
K
G
S
S
S
S
F
F
F
F
G
E
E
E
E
Fig. 4
Snap one corner roof tube (S) into each corner roof tube (E).
Insert corner roof tubes (E) and middle roof tubes (F) into the roof hub (G) as illustrated in Fig. 4.
Secure these roof tubes into each receiver with screws (K) using a Philips screwdriver.
□
□
□
K
88
Assembly (continued)
7
Attaching the roof frame
5
With a ladder in the center of the main frame, place the roof frame on the main frame.
Set the corner roof tube (S) in the brackets (H) with bolts (I) and nuts (L) using wrenches (P) and (R).
(Fig.5)
Set the middle roof tube (F) in the bracket in the middle of each complete cross beam
renches (P) and (R)
F
F
E
F
F
E
F
E
S
L
M
L
I
H
Fig.5
Cover all the bolts (I,J) with bolt caps ((M).
M
M
E
E
S
M
I
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Attaching the canopy and achoring the gazebo
6
Place the canopy (N) over the roof frame.
s at each corner of the canopy.
Set the middle roof tubes (F) into the remaining fabric pockets.
Adjust the position of each corner panel to make sure the frame is standing upright.
Hammer two ground stakes (Q) through the holes on each complete corner panel into soft ground. (Fig.6)
Q
Fig. 6
W
Measure out from corner roof tube (S) to the longest possible distance (to best use the length of the tie-down cords(V)) and secure each plastic
V
anchor (W) to ground
S
N
8
8
8
P
R
with bolts (I) and nuts (L) using w
M
44
8
Assembly (continued)
Attaching netting panels
7
Place 10 plastic rings (T) on each pair of cross beam (C) and (D).
From inside each corner of the main frame hang each piece of netting panel (U) on cross beams (C,D) with plastic rings (T).
Secure each netting panel to the corner panels from the inside of the garden house with the small hook and loop straps (1)
sewn on the outside of the panels.
With netting panels pulled to each corner, secure the netting panels to the corner panels with the large tiebacks (2)
found on the inside of the netting panels.
1
2
U
Retain this manual for future use.
HAMPTONBAY.COM
1-855-HD-HAMPTON
Questions, problems, missing parts? Before returning to the store,
call Hampton Bay Customer Service
8.00 a.m. - 7.00 p.m. EST, Monday - Friday,
9.00 a.m. - 6.00 p.m. EST, Saturday
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Hampton Bay 5LGZ1291-V3 Installation guide

Brand
Hampton Bay
Model
5LGZ1291-V3
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents