Wodgreat Handheld Shower Head User manual

Type
User manual
How to install wodgreat shower head?
---please cut off water before installation.
1. Remove old shower head, apply Teflon tape to shower arm.
Its an important step to prevent water leakage.
2. Ensure mesh washer was in bracket, then Install bracket to shower arm.
(Mesh washer was already installed in bracket, sometimes it may drop out in the box, just put
it back in).
3. Connect shower hose-- HEX NUT to shower bracket.
Please screw the nut instead of hose body.
4. Connect shower hose conical nut to handheld shower head.
(Please screw the nut instead of hose body).
Kindly reminds:
1. Shower hose has two different nuts, please ensure hex nut is connected with bracket and
conical nut is connected with shower head.
2. In case of leaking, please use Teflon tape certainly.
3. Don’t screw hose body, please hold the hose nut when screw in shower head or bracket.
To our customers:
We provide 7/24 service support and great warranty.
If you have any questions any time, please feel free to contact us via mail
wodgreat[email protected] and we will solve the issue for you soonest.
-- If you are satisfied with our products and service, we sincerely welcome you to share
your pleased shopping experience with other friends;
-- If you are not satisfied with our products or service, please just let us know and we
will make a refund to you without hesitation.
Thank you
Wodgreat
  • Page 1 1

Wodgreat Handheld Shower Head User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI