ToolPro TP04790 Operating instructions

Wall$Repair$Patch$Installation$

1.!!Prepare!the!surface.!!!

Sand!the!surface!area!large!enough!for!the!mesh!to!fit!into.!!If!the!surface!is!

wallpapered,!remove!the!paper!for!an!area!larger!than!the!mesh!so!it!may!be!

replaced!unseen.!!Wipe!the!area!clean!of!dust.!

2.!!Apply!the!self@adhesive!patch.!!!

Be!sure!the!mesh!patch!will!extend!at!least!½!inch!beyond!the!damaged!area!in!all!

directions.!!Remove!the!paper!cover!from!the!patch!and!apply!over!the!hole!with!the!

surface!covered!by!mesh!facing!outward.!!Firmly!press!the!mesh!onto!the!prepared!

surface.!

3.!!Apply!compound.!

Follow!the!mixing!directions!on!the!compound!container.!!Use!a!compound!

applicator!knife!to!spread!a!thin!layer!of!compound!evenly!over!the!patch.!!Feather!

the!compound!toward!the!edges!of!the!patch!so!the!patched!area!blends!with!the!

wall.!!Allow!to!dry.!

4.!!Finish!the!surface.!

Lightly!sand!the!dried!compound!with!a!sandpaper!of!100!grit!or!finer.!!!Do!not!sand!

into!the!mesh!patch.!!Once!the!surface!is!smooth,!paint,!wallpaper!or!texture!as!

desired.!

This manual is also suitable for

Download PDF