LBL Lighting BA1008OYPCLED930 Installation guide

Brand: LBL Lighting

Model: BA1008OYPCLED930

Type: Installation guide

Installation Instructions for

Steele 24 & 36

980STEELEW

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing

NEC compliant junction boxes.

This product is suitable for damp locations.

This product may be dimmed with a low-voltage electronic dimmer.

This product may be mounted horizontally or vertically.

Wall

1.0

BA1008_, BA1009_

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

Install the Mounting Plate

Remove the fixture screws located on the top and

bottom of the fixture base with the provided Allen

wrench.

Remove the mounting plate from the fixture base.

ELECTRICAL BOX

Install the mounting plate onto the electrical box with

the two #8-32 screws provided.

#8-32 SCREW

MOUNTING

PLATE

FIXTURE SCREW

ALLEN WRENCH

FIXTURE SCREW

7400 Linder Ave, Skokie, IL 60077

800.323.3226 - 847.626.6300

www.lbllighting.com

registered trademark of LBL Lighting. LBL Lighting reserves the right to

change specifications for product improvements without notification.

A Generation Brands Company

SAVETHESE INSTRUCTIONS!

Install the Fixture

Connect the mounting plate ground wire to a suitable

ground according to local electrical codes.

Connect the black driver wire to the hot power line wire

with a wire nut.

Connect the white driver wire to the neutral power line

wire with a wire nut.

Properly place all wires and wire nut connections into

the fixture base.

Mount the fixture by sliding it back onto the mounting

plate and reinstalling fixture screws (reversal of figure

1A).

LBL Lighting BA1008OYPCLED930 Installation guide

LBL Lighting BA1008OYPCLED930 Installation guide

LBL Lighting BA1008OYPCLED930 Installation guide

Related papers