Zebra WA6103 Installation guide

Brand: Zebra

Model: WA6103

Type: Installation guide

WORKABOUT PRO3 PISTOL GRIP WA6103

INSTALLATION GUIDE

Introduction

The Pistol Grip kit, model WA6103, is intended for use with WORKABOUT PRO3 and previous G2 units (models 7527C and

7527S) which have a backplate incorporating a switch.

Figure 1-1 Pistol Grip Kit Contents

Installation

1. If your unit is using AC power, disconnect it.

2. Remove the battery pack cover and battery.

3. Remove the screw-on cap, if present, from the switch in the middle of the backplate.

Figure 1-2 The Switch Location on the WORKABOUT PRO3

4. Lower the pistol grip handle into place over the backplate.

WARNING! The installation of this accessory must be performed using the appropriate anti-static devices. If unavailable,

discharge static from your body by touching a grounded metallic object before opening any covers on the unit.

IMPORTANT Back up any data in RAM first, since it will be erased when the internal power of the WORKABOUT PRO3 is turned off.

Pistol grip

Screws (x4)

Battery

Battery pack cover

Screw inserts

(x4)

Switch

© 2016 Symbol Technologies LLC, a subsidiary of Zebra Technologies Corporation. All

rights reserved. Zebra and the stylized Zebra head are trademarks of ZIH Corp.,

registered in many jurisdictions worldwide. All other trademarks are the property of their

respective owners.

8000173-001 Rev A 7/16

5. Fasten the four screws. Torque to 5.0 lb-in (Imperial) or 0.565 N·m (SI).

6. If your unit is using AC power, connect it.

7. Insert the battery.

8. Close the battery compartment.

9. Insert the stylus in the bottom of the pistol grip handle.

Trigger Switch Check

1. Turn the unit on.

2. Point the scanner at a bar code, and pull the pistol grip trigger switch to ensure that the scanner is scanning properly.

1
2

Zebra WA6103 Installation guide

Brand: Zebra

Model: WA6103

Type: Installation guide

Download PDF

Related papers

Other documents