Saniflo 082 Dimensions Guide

Saniflo
Brand
Saniflo
Model
082
Type
Dimensions Guide

Saniflo 082 is a macerating pump system that allows you to install a complete bathroom up to 15 feet below the sewer line or up to 150 feet away from a soil stack. It can handle human waste and toilet paper and discharges the waste through a 3/4" or 1" rigid pipe. The system includes a non-return valve to prevent backflow and a 1 1/2" vent connection for proper ventilation. The Saniflo 082 can also discharge gray water from sinks, baths/showers, or urinals and has two 2" inlets with built-in check valves for this purpose.

Saniflo 082 is a macerating pump system that allows you to install a complete bathroom up to 15 feet below the sewer line or up to 150 feet away from a soil stack. It can handle human waste and toilet paper and discharges the waste through a 3/4" or 1" rigid pipe. The system includes a non-return valve to prevent backflow and a 1 1/2" vent connection for proper ventilation. The Saniflo 082 can also discharge gray water from sinks, baths/showers, or urinals and has two 2" inlets with built-in check valves for this purpose.

EXTERNAL UNITS - SPECIFICATION SHEET
Discharges the waste through a
3
⁄4" or 1" rigid pipe. A non-return valve is included on the discharge elbow assembly provided with the
system. This elbow can be rotated 360 degrees depending on the discharge installation.
Has been designed with a 1
1
⁄2" vent connection on the top of the lid. All plumbing codes require connection to a vent system. Please note
that the vent system should be a two-way air vent as air needs to freely flow both ways. Note: The use of mechanical vents, air admittance
valves or similar devices is not permitted.
Must be connected to Saniflo’s 1.28 GPF rear discharge toilet. These toilets come in round and elongated
(ADA compliant) models. More technical information on page 5.
Will also discharge gray water from any sink, bath/shower or urinal. The wastewater will drain into the
system via two 2" inlets with built-in check valves on either side of the housing. Note that when adding
a bathtub/shower, the base should be raised up by a minimum of 6" off the floor.
Designed with two easy access service panels located on top of the pump. On one side
of the pump you can easily access the electrical components and the level sensor.
The other side allows access to the macerating blade for easy removal of foreign objects.
These toilets come in round and elongated
The wastewater will drain into the
on either side of the housing. Note that when adding
TECHNICAL SPECIFICATIONS
The Saniaccess3 is a 1/2 HP pump system used to install a complete bathroom up to 15 feet below the sewer line, or even up to 150 feet away
from a soil stack. It incorporates a macerating system which can handle human waste and toilet paper in residential applications.
The blade is made out of a hardened stainless steel material which eliminates the need for any service or replacement.
3
INSTALLATION BEHIND THE TOILET
INSTALLATION BEHIND THE WALL
Pump type: Macerator
Electrical: 120 V – 60 Hz / 4.5 Amps (Max)
Motor: 0.5 HP oil-filled thermally protected motor
Capacitor rating: 45 microfarad
Operating Temperature: 104 F° (110 F° Max.)
Power cord length: 51 inches
Noise level: ≤ 53 dBA (Lp) (measured at 3 ft.)
SANIACCESS3 • Part No. 082
Macerator
© SFA Sanifl o Inc. © SFA Sanifl o Inc.
28c
67
28c
66
28a
29
28a
53
28b
21c
21a
2c
28b
23
24
4
5a
63
3
20
13
10
11
12
58 32 64 56
37
36
35
34
1
2b
15
39
40
14
38
16
55
54
8
75
2d
7
61
9
6
30 30
17
2a
21d
28c
67
28c
66
28a
29
28a
37
28b
21c
21a
2c
28b
23
24
4
5a
63
3
20
13
10
11
12
64 56
37
36
35
34 30
57 28b1
2b
15
39
40
14
38
16
42
19
55
54
8
75
2d
7
61
9
6
17
2a
21d
41
PLEASE CALL US TOLL-FREE AT 800-571-8191 (US) / 800-363-5874 (CDN)
TO PURCHASE PARTS REFERENCED ABOVE
3
FOR ADDITIONAL TECHNICAL QUESTIONS, PLEASE CALL 800-571-8191
Round/Elongated Bowl
(Part No. 083 or 087)
Rear discharge toilet with 16
3
⁄4"
seating height (Elongated bowl
is ADA compliant). For more
information, please turn to
page 5.
Extension Pipe (Part No. 030)
18" long PVC pipe with internal
gasket used to hide the pump
behind the wall. For more
information, please turn to page 48.
Toilet Tank (Part No. 005)
Insulated 1.28 GPF toilet tank
equipped with all internal valves.
For more information, please turn
to page 5.
56.8 61.8 66.8 71.8 76.8 81.8 86.8 91.8 96.8 101.8 106.8 111.8
0
1
2
3
4
5
6
0
5
10
15
20
15 20 25 30
Flow Rate (liters/min)
Vertical Distance (m)
Vertical Distance (Feet)
Flow Rate (gallons/min)
Saniaccess3 (Part No. 082)
1/2 HP macerating pump for
residential applications. Dual
service access panels for periodic
maintenance and service.
Discharge pipe diameter:
3
⁄4" or 1"
Discharge rate at 15 ft: 17 GPM
Discharge rate at 3 ft: 27 GPM
Shut-off head: 30 ft.
Normal running time: 10-12s
Capacity: 3.1 gallons
Inlets: 2" (sides), 1
1
⁄2" vent (top)
Method of activation: Membrane/microswitch
Shower/bathtub base height: 6" min
Weight: 18 lbs.
Certifying agencies: CSA (IPC, NSPC), IAPMO (UPC)
Recommended accessories: Descaler
Connections: Rear outlet toilet, sink, shower/bathtub
1
3
⁄4"
13
1
⁄8"
10
3
⁄4"
17
1
⁄4"
18
3
⁄4"
3
⁄4"
8
7
⁄8"
6
3
⁄4"
1
5
⁄8"
1
1
⁄2"
1
1
⁄4"
7
1
⁄4"
2
1
⁄2"
  • Page 1 1
  • Page 2 2

Saniflo 082 Dimensions Guide

Saniflo
Brand
Saniflo
Model
082
Type
Dimensions Guide

Saniflo 082 is a macerating pump system that allows you to install a complete bathroom up to 15 feet below the sewer line or up to 150 feet away from a soil stack. It can handle human waste and toilet paper and discharges the waste through a 3/4" or 1" rigid pipe. The system includes a non-return valve to prevent backflow and a 1 1/2" vent connection for proper ventilation. The Saniflo 082 can also discharge gray water from sinks, baths/showers, or urinals and has two 2" inlets with built-in check valves for this purpose.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents