SAFETY INFORMATION
is luminaire must be installed in accordance with National Electrical Code and
local electrical and construction regulations. To assure full compliance with local
codes and regulations, check with your local electrical inspector before installation.
1.
To prevent electrical shock, turn o electricity at fuse box before installation.
2.
Do not exceed product specied luminaire voltage.
Any other source will void warranty.
3.
4.
Do not install if luminaire, parts or connectors are damaged.
Product must be installed with provided drivers and housings only. Use of other
manufacturers’ components will void warranty.
5.
MAINTENANCE AND CARE:
Disconnect the product form the
power supply before cleaning or
maintenance.
Page 1 of 1
R
Phone: 813.349.1900
Fax: 813.349.1907
2017-08-15
Warning:
is product contains chemicals known to the state of California to cause cancer, birth defects, and/or other
reproductive harm. oroughly wash hands aer installing, handling, cleaning, or otherwise touching this
product.
5022 Joanne Kearney Blvd.
Tampa, FL 33619
Installaon Instrucons for Recessed Round LED
1. The upper space above the ceiling height should be no less than 7
inches/140 mm (see FIG. 1)
2. Prepare the cutout hole on the ceiling (See FIG. 1)
Cutout size = Overall Diameter of Fixture - 0.5"
3. Punch out the knockout in the driver box and attach line voltage AC
supply wires to fixture lead wires (L-Black, N-White, G-Green or
Bare Copper Wire) inside the driver box. Secure each connection
u
sing the quick connectors provided. Fix the driver in a proper
position by screw.
4. Connect the lamp and the driver, turning the sleeve
counterclockwise to secure the connection (See FIG. 2)
5. Hold back spring clips and then push the lamp into the hole (See
FIG. 3)
6. Installation completed. Switch on.
Note: For wet locations. In accordance with UL requirements, a line
of caulking compound such as acrylic latex or silicone must be
placed around the perimeter of backplate also contacting the flange
(as shown in FIG. 5) to seal against mounting surface keeping water
away from the outlet box and back opening.
20mm
.79 in.
12 .7mm
0.5 in.
OFF
120V
90°
701341U 8", 18W, 2700K, 90 CRI 701351U 4", 10W, 2700K, 90 CRI 701361U 6", 15W, 2700K, 90 CRI
701342U 8", 18W, 3000K, 90 CRI 701352U 4", 10W, 3000K, 90 CRI 701362U 6", 15W, 3000K, 90 CRI
701343U 8", 18W, 3500K, 90 CRI 701353U 4", 10W, 3500K, 90 CRI 701363U 6", 15W, 3500K, 90 CRI
120-
277V
-
1
Ledpax Technology CE1006041 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Halo H471ICAT Installation guide
-
-
Pio Energy RP-T8P-12WXD1200 BIXX 5000K Installation guide
-
-
-
Thomson Lighting TASGU103K6,8F38 Datasheet
-
-
Verbatim 52606 User manual
-
Halo E7ICATNB Specification
-
SilberSonne HB90CWD Datasheet
