2. M-D Building Products
  3. 43309

M-D Building Products 43309, 43310, 43311, 43312 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the M-D Building Products 43309 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CLEAN
STEP 1
CUT
STEP 2
PEEL & ADHERE
STEP 3
CINCH
®
STAIR EDGING
INSTALLATION
INSTRUCTIONS:
STEP 1 - CLEAN: Make
sure the surface is
clean, dust-free, and
dry. To enhance the
adhesion, we
recommend the
surface be sealed or
primed prior to placing
tape on stair step. Not
recommended for
carpeted stair steps.
STEP 2 - CUT: Measure
and cut Cinch Stair
Edging to intended
length using a
hacksaw or power saw.
STEP 3 - PEEL &
ADHERE: Peel away
the film backing from
Cinch Stair Edging
exposing the adhesive.
With the Cinch Stair
Edge face fitting
securely up against
stair step vertical riser,
place Cinch Stair Edge
(and adhesive tape) on
the stair step. Apply
firm and consistent
pressure across the
Cinch Stair Edge in
order to properly
adhere to the surface.
Wait 60 minutes
before walking on
Cinch Stair Edging.
Note: Do not install
Cinch Stair Edging
below 50° F.
Tools Required :
/