Page is loading ...
Authorization Code Levels
AK-SC 255
Service Guide
ADAP-KOOL® Refrigeration Control System
Service Guide | Authorization Code Levels | AK-SC 255
© Danfoss | ADAP-KOOL® | 2018.08
2 | AX279033472246en-000101
Supervisor:
1. Allows everything to be viewed and changed including access
codes.
Complete: Allows everything that Supervisor can do EXCEPT:
1. View and change passwords
2. Alter dialout info (phone name, phone #, phone schedule, etc.)
3. Alter history setup (or clear out history)
4. Alter modem setup
Refrigeration - All:
1. Can change refrigeration and lighting, both settings and
configuration
HVAC - All:
1. Can change HVAC and lighting, both settings and configuration
Refrigeration - Set:
1. Can change refrigeration or lighting settings but not
configuration:
2. So you can't add or remove a circuit (need Ref‐All or higher for
that)
3. You can't change a board and point assignment
4. You can not change an alarm setpoint.
5. If you can get to a setpoint in the Status screens, you can
change it with a Ref‐ Set auth code. You could for example, put
an offset on a sensor, or put a compressor manual on or off but
you couldn't move that sensor or that relay to a different board
and point assignment.
HVAC - Set:
1. Can change HVAC or lighting settings but not configuration:
2. Relationship between HVAC-Set and HVAC-All is similar to that
between Ref-Set and Ref-All.
Alarms:
1. Allows alarms to be acknowledged and most other screens,
except access codes can be viewed, but changes cannot be
made.
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alternations can be made without subsequential changes being necessary in specifications already agreed.
All trademarks in this material are property of the respecitve companies. Danfoss and Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
/