Philips hr 2304 User manual

Page is loading ...

6

Introduction

Congratulations on your purchase and welcome to Philips! To fully benet from the support that

Philips offers, register your product at www.philips.com/welcome.

General description (Fig. 1)

A Motor unit

B On/off switch

C Release button to remove the motor unit from the lid

D Release slide to detach the lid with motor unit from the bowl

E Mains cord

F Lid

G Filling opening

H Stirrer

I Cooling disc

J Bowl

Important

Read this user manual carefully before you use the appliance and save it for future reference.

Danger

Never immerse the motor unit in water nor rinse it under the tap.

Warning

Check if the voltage indicated on the appliance corresponds to the local mains voltage before

you connect the appliance.

Do not use the appliance if the plug, the mains cord or the appliance itself is damaged.

If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by

Philips or similarly qualied persons in order to avoid a hazard.

This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given

supervision or instruction concerning use of the appliance by a person responsible for their

safety.

Children should be supervised to ensure that they do not play with the appliance.

Caution

Never use any accessories or parts from other manufacturers or that Philips does

not specically recommend. If you use such accessories or parts, your guarantee becomes

invalid.

This appliance is intended for household use only. If the appliance is used improperly or for

professional or semi-professional purposes or if it is not used according to the instructions in

the user manual, the guarantee becomes invalid and Philips refuses any liability for damage

caused.

When you make ice cream, hygiene is of the utmost importance. Make sure that all parts of the

ice-cream maker are entirely clean, especially the parts that come into contact with the ice-

cream mixture.

If ingredients freeze onto the cooling disc, the stirrer does not function properly. To prevent this,

only put ingredients in the bowl while the stirrer is rotating and do not switch off the

appliance before the ice cream is ready.

Never insert an object, e.g. a spoon, into the bowl while the appliance is operating.

Never exceed the quantities indicated in the recipes.

-

ENGLISH

Safety shut-off function

The ice-cream maker is equipped with a safety shut-off function. After 120 minutes of operation and

also if overloading occurs, the motor is switched off automatically.

Electromagnetic elds (EMF)

This Philips appliance complies with all standards regarding electromagnetic elds (EMF). If handled

properly and according to the instructions in this user manual, the appliance is safe to use based on

scientic evidence available today.

Preparing for use

Freezing the cooling disc

1 Make sure that the cooling disc is clean and dry.

2 Put the cooling disc in the freezer or in the freezer compartment of a refrigerator to cool it

to the required temperature of -18°C/0°F or colder.

It takes 18 to 24 hours to freeze the cooling disc.

Do not place other objects on top of or against the cooling disc while it is being frozen.

3 Store the cooling disc with the bottom pointing downwards in a well-closed plastic bag in the

freezer to prevent ice from forming on the cooling disc. In this way, the disc is always ready

for use.

4 Remove the cooling disc from the freezer after you have prepared the ingredients for the ice

cream.

Note: Always make sure that the cooling disc is properly frozen when you put it in the ice-cream maker.

Using the appliance

How does the ice-cream maker work?

The ice-cream maker contains a frozen cooling disc. This disc quickly cools down the ingredients

while the stirrer rotates. The mixture is stirred until it has turned into ice cream.

Note: The cooling disc is lled with a non-toxic saline solution.

Making ice cream

1 Prepare the mixture of ingredients for the ice cream in a separate bowl.

Preferably use ingredients at refrigerator temperature.

Note: You can nd delicious recipes and many tips in the separate recipe booklet.

Note: Do not exceed the quantities indicated in the recipes. If you do, the ice-cream may become less

compact.

2 Remove the cooling disc from the freezer and take it out of the plastic bag.

Make sure your hands are dry when you handle the frozen cooling disc.

3 Check if the disc is properly frozen and free of ice.

If the disc is properly frozen, its contents have turned hard all over.

If the disc is not properly frozen, you hear a crunching sound when you press the bottom of the

disc with your thumbs.

If a thin lm of white frost has developed on the cooling disc, remove it with a wooden or

plastic spatula. Do not use metal utensils for this purpose to prevent damage.

-

ENGLISH 7

Do not rinse the frozen cooling disc, as this cause a thick lm of ice to develop on the outside of

the disc right away.

4 Place the frozen cooling disc in the bowl of the ice-cream maker (Fig. 2).

5 Insert the front edge of the motor unit into the lid. (Fig. 3)

6 Push the motor unit downwards into the lid until it locks into place (‘click’) (Fig. 4).

7 Insert the stirrer into the hole of the motor unit (‘click’) (Fig. 5).

8 Place the lid with motor unit on the bowl in the correct position. Turn the lid clockwise until

it locks into place (‘click’) (Fig. 6).

9 Put the mains plug in the wall socket and switch on the appliance.

Always switch on the appliance before you put the ingredients in the bowl. This is necessary to

prevent the ingredients from freezing onto the cooling disc right away.

10 Pour the mixture of ingredients into the ice-cream maker through the lling opening in the

lid.

11 Let the ice-cream maker work until the ice cream has the right consistency.

The preparation time greatly depends on the type of ice-cream mixture and the temperature of the

ingredients. It takes about 40 minutes to make compact ice cream and about 20 minutes to make

soft ice cream.

Tips

Do not switch off the appliance too early. If you switch off the appliance too soon, the

ingredients freeze onto the cooling disc. This makes it impossible for the stirrer to continue

rotating in case the ice cream is not ready yet.

Do not let the ice-cream maker operate too long. Switch it off as soon as you see that the ice

cream starts to melt at the surface or on the sides.

It is not possible to make another batch of ice cream right away, because the cooling disc must

rst be properly frozen again. If you want to be able to make two batches of ice cream in a

row, order an extra cooling disc.

After use

1 To remove the lid, pull the release slide towards you (1) and turn the lid anticlockwise

(2) (Fig. 7).

2 Remove the ice cream from the bowl.

3 Pull the stirrer out of the motor unit. (Fig. 8)

4 Press the release button and remove the motor unit from the lid (Fig. 9).

5 Remove the cooling disc from the bowl (Fig. 10).

Cleaning

Always disassemble the ice-cream maker and clean its parts after use.

1 Make sure the appliance is unplugged.

2 Clean the lid (without the motor unit!), the stirrer and the bowl in hot water with some

washing-up liquid. Clean the cooling disc in lukewarm water (max. 40°C/100°F) with some

washing-up liquid.

These parts are not dishwasher-proof!

3 Clean the motor unit with a damp cloth.

-

ENGLISH8

Never immerse the motor unit in water nor rinse it under the tap.

Replacement

The following accessories are available from your dealer:

Transparent lid (no. 4822 441 80844)

Stirrer (no. 4822 690 40258)

Cooling disc (no. HR2968 or no. 4822 511 90025)

Bowl (no. 4822 418 40898)

Tip: An extra cooling disc (HR2968) enables you to prepare larger quantities of ice cream or two

different avours.

Environment

Do not throw away the appliance with the normal household waste at the end of its life, but

hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the

environment (Fig. 11).

Guarantee & service

If you need information or if you have a problem, please visit the Philips website at www.philips.com

or contact the Philips Customer Care Centre in your country (you nd its phone number in the

worldwide guarantee leaet). If there is no Customer Care Centre in your country, go to your local

Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal Care

BV.

Troubleshooting

If problems arise with your ice-cream maker and you cannot solve them with the information below,

please contact the nearest Philips service centre or the Philips Customer Care Centre in your

country.

Problem Cause Solution

The appliance

does not start

operating.

There is a connection

problem.

Check if the plug is inserted in the wall socket

properly. Remove the mains plug from the

wall socket and reinsert it.

The lid has not been

properly attached to the

bowl.

Place the lid with motor unit on the bowl in

the correct position. Turn the lid clockwise

until it locks into place (‘click’).

The stirrer does

not rotate.

You put the mixture of

ingredients in the bowl

before you switched on the

appliance. This has caused the

ingredients to freeze onto

the cooling disc.

Always switch on the appliance before you

put the ingredients in the bowl.

The cooling disc

cannot be

removed from

the bowl.

The cooling disc has frozen

onto the bottom and walls

of the bowl.

Let the cooling disc defrost for a few hours

until it has come loose from the bottom and

walls of the bowl. You can speed up this

process by pouring some lukewarm water

into the bowl.

-

,

ENGLISH 9

Page is loading ...

Philips hr 2304 User manual

This manual is also suitable for

Philips hr 2304 User manual

in other languages

Related papers

Other documents