Antec EASY USB User manual

Brand: Antec

Model: EASY USB

Type: User manual

Antec EASY USB makes using USB peripherals easier by providing front USB connectors and acting as a drive conversion kit. It allows you to mount a 3.5" device in a 5.25" drive bay, enabling easy connection of USB peripherals without reaching the back of your computer. Installation involves removing a 5.25" drive cover, securing your device with included screws, mounting the Easy USB into your case, and connecting the cables as per your motherboard's USB pin-out. Remember to enable the USB port in your motherboard's BIOS settings.

Make using USB peripherals easier. Easy USB allows you to utilize the front USB connectors on many

new motherboards through a 5.25” drive bay. At the same it acts as a drive conversion kit so you can mount

a 3.5" device in the 5.25" drive bay. So in one product, you get both a drive conversion kit and front USB

interface ports. With this set up you can then easily attach more USB peripherals without having deal with

connecting them to the back of your computer.

Installation instructions:

On your case remove a 5.25” drive cover from an open 5.25” drive bay. Make sure the EMI shield

(metal plate behind the drive cover) is also removed.

To install your external 3.5” device into the Easy USB, first remove the drive cover. Then use the included

screws to secure the device through the screw holes on the bottom of the Easy USB. For internal (hard

drives) 3.5” devices, you do not need to remove the drive cover. Otherwise installation is the same as for

external 3.5” devices.

Next, mount the Easy USB into your case, with the screws provided.

Now you can start connecting the cables. The cables with two ends - one end with one 10-pin connector and

the other end with two 5-pin connectors. Connect the 10-pin connector to the back of the Easy USB. It

will only connect one way. Connect the other two 5-pin connectors to your motherboard as described

below.

Note: Consult your motherboard manual or manufacturer for the exact USB pin-out of your

motherboard before connecting.

1. First identify the USB connector on your motherboard. It should be a 10-pin, two-row connector with

one power pin on each of the rows.

2. Connect either of the 5-pin connectors to a row first. Make sure you align the red wire (marked with

“power”) with the power pin.

3. Repeat the same procedure to connect the other connector.

4. In most situations, pin 1 and 2 are the power pins. There may be some exceptions. Make sure you

consult your motherboard manual first.

Visit our web site at http://www.antec-inc.com/specs/ezusb.html

To see a diagram of a typical USB connector pin-out.

5. Go to your motherboard BIOS settings and make sure the USB port is enabled.

Installation is now complete.

Antec EASY USB User manual

Antec EASY USB User manual

Antec EASY USB User manual

Related papers

Other documents