GB-1 GB-2
P R O D U C T O V E R V I E W
U N PA C K I N G
Remove all packaging from the unit. Retain the packaging. If you dispose of it
please do so according to local regulations.
The following items are included:
This kettle must only be used with
the stand provided.
Do not insert any foreign objects or allow any liquid to spill into the
Power Connector Hole.
If the kettle is overlled,
boiling water may be ejected
from the spout and cause
scalding.
• Never open the lid while the water is
boiling. The steam coming out from the
kettle is very hot.
• If there is insufficient water in the kettle,
the automatic safety cut-out will
operate. If this happens, allow the
kettle to cool for ten minutes before
relling with cold water and re-boiling.
• Ensure that the switch is not obstructed
and the lid is rmly closed. The kettle
will not turn o if the switch is
obstructed or if the lid is open.
• After removing the kettle, there may be
some water on the surface of the stand.
This is condensation from the steam
that causes the kettle to automatically
switch off after boiling. This is normal
and should not be a cause for alarm.
Open Switch
Handle
5
6
Power Switch
7
Mains Cable
Slot
8
Lid
Spout
1
2
Water Fill Level
Kettle Stand
3
4
GB-3
F I L L I N G T H E K E T T L E
Slide the open switch to open the lid and ll the kettle with the required amount of
water.
Do not exceed the maximum ll level (Max 1.7L) as indicated inside the kettle and not
less than the minimum ll level (Min 0.75L).
S W I TCHING ON
Place the kettle on the stand. Connect the stand’s mains cable to the mains socket.
Press the power switch to the ON position (indicated by the symbol ‘I’).
The indicator inside the power switch of the kettle will light up to indicate that the
kettle is heating.
C L E A N I N G T H E K E T T L E
The kettle exterior should be cleaned with a soft damp cloth. Do not use abrasive
cleaners or scouring pads which may damage the nish of the kettle.
Never immerse the kettle or the stand in water and always keep the electrical
contacts dry. Always disconnect the stand from the mains before cleaning .
D E S C A L I N G T H E K E T T L E
Depending on the hardness of the water in
your area, limescale may be deposited on the
heating element and the inside of the kettle.
This normal build-up is not harmful to health
but an excessive amount of scale may affect
the performance of the kettle.
To descale, ll the kettle with distilled water
up to three-quarters of the Max level and
bring the water to boil. After the kettle has
switched o, add a descaling solution
following the manufacturers instructions.
Never attempt to descale the kettle by
chipping or scraping with a sharp implement.
W H E N T H E WAT E R H A S B O I L E D
The kettle will automatically switch off (indicated by the symbol ‘0’ ).
1
6
5
7
8
2
3
4
• The Main Unit • Instruction Manual
(P.N.: C17JKW11-001)
90˚
F I R S T T I M E U S E
Clean your kettle by boiling a full kettle of water twice and then discarding the
water.
K E E P I N G T H E M A I N S C A B L E T I DY
Extend the mains cable in the kettle stand
to the required length. Locate the mains
cable in the slot in the stand. For safety it is
recommended that the length of exposed
mains cable is kept as short as possible.
Power Connector Hole
C L E A N I N G T H E R E M O VA B L E S C A L E F I LT E R
To prevent loose particles of limescale
being poured into your beverage, your
kettle is tted with a scale lter. You may
remove the lter and t it back in after
cleaning.
To remove the lter, open the lid, then lift
up the lter from the spout.
To replace the lter, open the lid, place the
lter at the spout and push it down till it
ts in place.
K ET TL E
In st ru ct ion M an ua l
C1 7J KW 11
Thank you for purchasing your new Currys Essentials Kettle.
We recommend that you spend some time reading this instruction
manual in order to fully understand all the operational features it
offers.
Read all the safety instructions carefully before use and keep this
instruction manual for future reference.
C
M
Y
CM
MY
CY
CMY
K
C17JKW11_IB_110712.pdf 2 12/07/2011 4:16 PM