Warrior Products 90710 Installation guide

==============================================================================================

SUBJECT: Part #90710 Gas Tank Skid Plate Installation Instructions

Important: This installation is best done with an empty tank of fuel. It will be difficult to manage the tank with too much fuel

in it. Also note that this is a replacement skid plate, the existing plate will need to be removed in order to install this one.

1. Begin by supporting the gas tank with a floor jack. A piece of wood to distribute the load across the skid will also

help in lowering it steadily.

2. Along the front and back edges of the skid are bolts holding it in place. Remove these bolts.

3. Lower the skid. You may be able to let your tank hang while you swap the skid out.

4. Inspect your gas tank straps and if not in good shape, replace them. Rusty straps should not be re-used.

5. Load your new skid onto the jack and reverse the process to raise it into place.

6. Bolt the new skid into place and lower the jack out of your way

Be careful not to damage any fuel lines or filler neck hoses while doing this installation.

To see more Warrior accessories available for your Wrangler, please visit us online at www.warriorproducts.com.

Warrior, Inc.

11100 SW Industrial Way

Tualatin, Oregon 97062

(503) 691-8915 Main

(503) 692-0364 Fax

(888) 220-6861 Toll Free