Maximum Wall Mount Owner's manual

Maximum
Brand
Maximum
Model
Wall Mount
Category
Network antennas
Type
Owner's manual
18” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 1
PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR,
ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,
OR HARDWARE STORE FOR REFERRALS).
Slip the swaged end of mast A into the
round end of mast B.
1
2
WOOD BLOCK
SWAGED END
Tap the two sections together with a hammer.
A piece of wood will protect the end from
damage.
MAST B
MAST A
MAST B
MAST A
Bolt two half-sections together to make one
complete top bracket assembly
3a
7/16”
HAMMER
TAPE MEASURE
7/16” WRENCH
3/8”
3/8” WRENCH
TOOLS
REQUIRED
DRILL WITH
1/8” DRILL BIT
PHILLIPS SCREW
DRIVER
LEVEL
CLAMPING
SCREWS
LAG
SCREW
SWAGED END
SUPPORT
LEG
SLOTTED SCREW
DRIVER
TOP BRACKET ASSEMBLY
18” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 2
3b
Bolt the remaining two half-sections together
with the support leg between to make one
complete bottom bracket assembly. The
support leg must be secured utilizing hole “B”
and oriented so that the bent flange will be
flush against the wall.
A
B
Must be oriented so that
flanged end will be flush
against the wall.
SUPPORT
LEG
ROOF
PEAK
1/8” PILOT
HOLES
18”
MINIMUM
LEVEL
14 1 2”
Drill two 1/8” level pilot holes 14 1 2” apart for each
bracket. Brackets must be separated from each
other by at least 18” for mast stability. Both
brackets must be aligned vertically for the mast
to be straight when installed.
5
Must be positioned
so that leg will utilize
hole “B”
BRACKET WILL
ACCOMMODATE
UP TO 18 INCHES
OVERHANG OF EAVE
MAST
ROOF
PEAK
4
Select a location that will be
high and free from any obstructions
to air flow for the sensors.
BOTTOM BRACKET ASSEMBLY
18” WALL MOUNT
INSTALLATION
30 Samuel Barnet Blvd.
New Bedford, MA 02745
(508) 995-2200
Page 3
LAG
SCREWS
18 INCH
BRACKET
ROOF
PEAK
6
Secure the brackets
with the lag screws
7
Hold the lower bracket, support leg combination
so that it is level. Drill a 1/8” pilot hold and secure
the lower end of the support leg with a lag screw.
LEVEL
LEG SCREW
ROOF
PEAK
8
Slip mast into brackets and secure
with the clamping screws.
CLAMPING SCREWS
MAST
  • Page 1 1
  • Page 2 2
  • Page 3 3

Maximum Wall Mount Owner's manual

Maximum
Brand
Maximum
Model
Wall Mount
Category
Network antennas
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents