For more information, visit www.fmiproducts.com
C36TU and C36TO
Corner Mantel and Base
ASSEMBLY AND INSTALLATION INSTRUCTIONS
IMPORTANT: Read entire instruction sheet be-
fore assembling or installing mantel kit.
These mantels are only approved for use with
any FMI PRODUCTS, LLC 36'' electric and gas
replace systems. Do not use mantel with any
other product.
• Thismantelkitcontainsthefollowing:
#1Base
#2RightSideAssembly
#3LeftSideAssembly
#4Header
#5Top
#6TopTriangle
#7TopLeftSupport
#8TopRightSupport
#9TopCenterSupport
#10BaseSupport
#11VerticalSupport
RightTopTrimStrip
LeftTopTrimStrip
• HardwarePackage
36-11/4"WoodScrews114325-01
8-1"FinishingNails114295-04
4-2"WoodScrews122447-01
*Extrahardwaremaybeincluded
Toolsrequired:
• PowerScrewdriverwith#2PhillipsBit
• Hammer
• NailSet
Ifanywoodpiecesaremissingordamaged,contactthedealer
whereyoupurchasedthismantelforreplacement.Ifhardware
is missing or damaged, contact FMI PRODUCTS, LLC at
1-866-328-4537 forreferral information. You can also visit
FMIPRODUCTS,LLC’swebsiteatwww.fmiproducts.com.
WARNING: Follow guidelines of paint or n-
ish manufacturer. Use care when nishing or
painting an unnished mantel (C36TU only). Do
not nish or paint mantel pieces near running
heater or open ame. These vapors are highly
ammable.
IMPORTANT:Ifyouarestaininganunnishedmantel(C36TU
only),removeanysawdust,dirtoroils.Thiswillpreventblem-
ishes from appearing under the stain. Stain mantelbefore
assemblingaccordingtomanufacturer’sinstructions.Apply
sandingsealer.
IMPORTANT:Ifyouarepaintinganunnishedmantel(C36TU
only),assemblemantelbeforepainting.Followdirectionslisted
onpaintforwoodproducts.Applybasecoatandtopcoatfol-
lowingdirectionslistedonproduct.
Note: Gather all mantel pieces together before assembling
mantel.
WARNING: Only use 1 1/4" screws to as-
semble mantel. Damage to mantel will result if
other screws are used for this purpose.