Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Installation instructions
Noblesse 14/6 Refrigerator
Built-in EURO 60
J927.510-1
18.8.11 HGSI
7
These installation instructions apply to the model: 927
➤ Information on the necessary mains voltage, type of current and fuse protection can be taken from the identification plate.
➤ Ensure that the appliance is switched off if it is not intended that the appliance be used immediately after installation.
➤ Operate the appliance in accordance with the operating instructions supplied.
The appliance should be installed by qualified personnel only. Each step must be carried out and checked in full in the order
specified.
Validity
General notes
If installing into combustible material, the guidelines and safety standards for low voltage installations and fire protection must
be strictly observed.
Electrical connections
Electrical connections must be carried out by suitably qualified personnel in accordance with the guidelines and safety
standards for low voltage installations and the specifications of the local electricity supply companies.
A plug-in appliance may only be connected to a socket outlet with earthing contact, installed according to specifications. A
mains isolating device with 3 mm contact opening should be provided in the house wiring system. Switches, plug and socket
devices, circuit breakers and fusible cut-outs which are accessible after installation and which have all-poles switching are
permissible as isolating devices. Effective earthing and separately installed neutral and earth conductors ensure safe and fault-
free operation. After installation, live parts and cables with basic insulation must not be accessible. Check old installations.
Note on installation
Installation instructions
Noblesse 14/6 Refrigerator
Built-in EURO 60
J927.510-1
18.8.11 HGSI
8
Builtin EURO 60 Integratable door
*
Allow a gap less than the width of the appliance (top and bottom) to ensure proper ventilation (SMS sheet 5-08). Shadow gaps alone
– even if extended over several elements – are not sufficient.
2050 (SMS norm) flush-mounted power socket, type 13
Positioned ABOVE
standard
Positioned BELOW
also possible
120
100
Width of element 600
Niche 1778 =14/6
+2
0
Appliance 1776
=
=
min. 50
min. 200 cm²
min. 200 cm²
*Ventilation cross-section
Door panels
Appliance 545
a
min. 4
b
min. 4
+2
0
Niche1778 =14/6
Door leaves
508
1270
a
16–20
16–20
Niche 560–568
Appliance 548
100˚
Niche 550
ca. 602
Filler strip H7.1756
(request when ordering
appliance)
For door panel thickness greater
than 20 mm, see H7.0314
max. 594
1270+a-b
2b
508+a-b
A
Detail A
Door panels
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
in other languages
- italiano: V-ZUG 927 Guida d'installazione
- français: V-ZUG 927 Guide d'installation
- Deutsch: V-ZUG 927 Installationsanleitung
