ATEN IC-422 User manual

Brand: ATEN

Model: IC-422

Type: User manual

ATEN IC-422 is equipped with two high-speed RS-422/485 serial ports with 32 bytes of FIFO storage capacity and can reach speeds of up to 960 Kb/s. The device has two mini terminal block type connectors for four-wire standard telephone cables. The IC-422 is compatible with Win 98, ME, NT4, Win 2000/XP, Win 3.1, DOS, and Linux. The IC-422 is suitable for connecting peripherals such as modems and scanners.

User Manual

IC-422

Read this guide thoroughly and follow the installation and operation

procedures carefully in order to prevent any damage to the units and/or

any devices that connect to them.

This package contains:

M 1 IC-422PCI Card

M 1 User Manual

If anything is damaged or missing, contact your dealer.

International Co., Ltd.

Manual Part No. PAPE - xxxx-xxx

Printed in Taiwan 12/2003

All brand names and trademarks are the registered property of their respective owners.

2003-12-18

Note: This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and

can radiate radio frequency energy, and if not installed and

used in accordance with the instruction manual, may cause

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful

interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more

of the following measures:

M Reorient or relocate the receiving antenna;

M Increase the separation between the equipment and

receiver;

M Connect the equipment into an outlet on a circuit different

from that which the receiver is connected;

M Consult the dealer or an experienced radio/television

technician for help.

2003-12-18

Overview

The IC-422 PCI card comes equipped with two High-Speed

RS-422/485 standard serial interface ports, each with 32 Bytes

of FIFO storage capacity and the ability to reach speeds of up

to 960 Kb/sec. The IC-422 provides two mini terminator block

type connectors for the attachment of four wire standard

telephone cable.

Features

2 Mini four wire terminal block connectors

40 Mbps max data transfer rate (250 K baud on networks of

up to 64 nodes)

Compatible with Win 98, ME, NT4, Win 2000/XP, Win 3.1,

DOS and Linux

- 1 -

2003-12-18

Hardware Installation

1. Power off your computer.

2. Plug the card into any available PCI bus slot.

3. Connect your peripherals (modem, scanner, etc.) to the

terminal block.

4. Power on your computer.

- 2 -

Before you begin, make sure that power to all the

devices you will be connecting up have been

turned off. You must unplug the power cords of

any computers that have the Keyboard Power On

function.

2. To prevent damage to your equipment, make sure

that all devices you will be connecting up are

properly grounded.

2003-12-18

Pin Assignments

Half Duplex (2 wire) for RS-485

Full Duplex (4 wire) for RS-422/485

- 3 -

2003-12-18

Jumper Settings

Technical Specifications

Function Specification

Connectors 2 x 4 Wire Terminl Blocks

Chips 1 x Sun 1889

Compatibility 32 Bit PCI card for 486/586/Pentium

/Pentium II/P III/C5/K6

Operating System Win 95, 98, NT, 2000, XP, OS/2, Linux,

DOS, Win 3.1

PCB 2 Layer / 120 x 104 mm

- 4 -

2003-12-18

Troubleshooting

Problem Solution

Computer returns an error

when booting up

Try a different slot.

Clean the slot contacts.

Clean the card contacts.

If these don’t remedy the problem, contact your dealer for

further assistance.

Limited Warranty

IN NO EVENT SHALL THE DIRECT VENDOR’S LIABILITY EXCEED

THE PRICE PAID FOR THE PRODUCT FROM DIRECT, INDIRECT,

SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES

RESULTING FROM THE USE OF THE PRODUCT, DISK, OR ITS

DOCUMENTATION.

The direct vendor makes no warranty or representation, expressed,

implied, or statutory with respect to the contents or use of this

documentation, and especially disclaims its quality, performance,

merchantability, or fitness for any particular purpose.

The direct vendor also reserves the right to revise or update the device

or documentation without obligation to notify any individual or entity of

such revisions, or update. For further inquiries, please contact your

direct vendor.

- 5 -

2003-12-18

Notes:

- 6 -

2003-12-18

ATEN IC-422 User manual

ATEN IC-422 User manual

Related papers

Other documents