AKUART Installation Manual | SmartDivider
1 // 4
INSTALLATION MANUAL
SMARTDIVIDER
AKUART Installation Manual | SmartDivider
2 // 4
TOP WIRES (200 cm)
- used to attach the top row of SmartDividers to the ceiling mounts
- two per column
CONNECTOR WIRES (20 cm)
- two for each middle- and bottom row frames
CEILING MOUNTS
- used to attach the top row of SmartDividers to the ceiling
- two per column
FLOOR WIRES (100 cm)
- two per column
FLOOR ATTACHMENT KIT (OPTIONAL)
FLOOR MOUNTS
- two per column
SMARTDIVIDER FRAME
- comes with four wire locks pre-installed, two in top, two in bottom
RAWL PLUGS
- two needed per column
- must be appropriate size for screws
- must be appropriate for ceiling material
WIRE CUTTERS
- for trimming excess wire
POWER DRILL
- drill bit must be appropriate size for rawl plugs
SCREWS
- body diameter max. 5 mm
- must be appropriate size for rawl plugs
LASER LEVEL (suggested)
- helps with alignment of frames and drilled holes
COMPONENTS (included)
TOOLS NEEDED (not included)
1
2
SmartDivider frame
AKUART Installation Manual | SmartDivider
3 // 4
- For each top wire supplied, attach the ceiling mount as illustrated below.
A) Drill holes in ceiling, add rawl plugs.
B) For each row of SmartDividers, the distance between the two holes is 45 cm.
D) Screw hooks with attached top wires into holes in ceiling.
E) The distance between two rows of SmartDividers is 8 cm, which is the same distance as the distance from the side of the SmartDivider to the wire.
F) Insert the ends of the top wires into the wire locks on the SmartDividers. Depress the wire lock to release the wire again.
G) The top wires can be trimmed to the desired length from ceiling to the top of the SmartDivider columns, plus an additional 5 cm, using wire cutters.
Do this before inserting the wires into the wire locks.
45 cm 45 cm24 cm
8 cm8 cm 8 cm
24 cm
8 cm8 cm 8 cm
ASSEMBLY - TOP WIRES + CEILING MOUNTS
INSTALLATION - TOP WIRES
3
top wire (200 cm)
1
4
2
B
D
F
E
G
3
C
4 5 6
SmartDivider frame
wire lock
ceiling
wire lock
SmartDivider frame
wire cutter
5 cm
desired length from
top of column to ceiling
ceiling mount
ceiling
AKUART Installation Manual | SmartDivider
4 // 4
A) Use the short connector wires to connect each row to the next as needed.
B) The distance between each row of SmartDividers is 8 cm, the same as the distance between each column.
C) To adjust the distance between two SmartDivider frames, either push the wire further into the wire lock, or depress the wire lock until it releases the wire.
D) Optional: use a laser level to align the columns and rows.
INSTALLATION - ADDITIONAL ROWS
5
B
C
D
connector wire (short)
connector wire (short)
ceiling
SmartDivider frame
8 cm
SmartDivider frame
8 cm
SmartDivider frame
laser level
SmartDivider frameSmartDivider frameSm
a
rtDivi
d
er
f
r
a
m
e
8 cm
/