Chief PAC710-G User manual

Category
Flat panel accessories
Type
User manual

Chief PAC710-G is a shelf accessory designed to be attached to Listed Chief MFC Series carts. It is intended to be used for supporting equipment such as video equipment, computer monitors, and other items that weigh less than 25 lbs (11.34 kg). The shelf is installed below the adjustment knob on the center post of the cart. It comes with a 6 ft. strap for securing equipment to the shelf. The shelf has cable management slots to help keep cords organized.

Chief PAC710-G is a shelf accessory designed to be attached to Listed Chief MFC Series carts. It is intended to be used for supporting equipment such as video equipment, computer monitors, and other items that weigh less than 25 lbs (11.34 kg). The shelf is installed below the adjustment knob on the center post of the cart. It comes with a 6 ft. strap for securing equipment to the shelf. The shelf has cable management slots to help keep cords organized.

INSTALLATION INSTRUCTIONS
Shelf Accessory
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
PAC-710
PAC-710 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively “Milestone”), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to this accessory does not exceed
25 lbs (11.34 kg).
WARNING: Use this accessory only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
WARNING: Never operate this accessory if it is damaged.
Return the accessory to a service center for examination and
repair.
WARNING: Do not use this product outdoors.
WARNING: RISK OF INJURY TO PERSONS! Do not use
this accessory to support video equipment such as
televisions or computer monitors.
IMPORTANT ! :
The PAC-710 is intended to be attached to
Listed Chief MFC Series carts.
--SAVE THESE INSTRUCTIONS--
LEGEND
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Installation Instructions PAC-710
3
PARTS
A (1)
B (1)
[PAC710]
[6 ft. strap]
PAC-710 Installation Instructions
4
INSTALLATION
WARNING: IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute
hardware! Use only hardware provided by manufacturer.
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY
MAY LEAD TO SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the user’s responsibility to
ensure the total amount of weight placed on the shelf does
not exceed 25 lbs (11.34 kg).
Shelf Installation
The PAC-710 is designed to be mounted onto the MFC Series
carts. The shelf may only be installed BELOW the adjustment
knob on the center post. (See Figure 1)
Figure 1
1. Loosen back bracket on shelf (A) by turning both knobs
counterclockwise to loosen them. Do NOT remove knobs.
(See Figure 2)
Figure 2
2. Slide bracket to the left until it disengages from the shelf’s
right stud. (See Figure 3)
Figure 3
3. Let the bracket drop down and hang from the shelf’s left
stud. (See Figure 4)
Figure 4
4. Shelf should be located directly above or directly below a
cable management opening in the post. (See Figure 5)
Figure 5
Install shelf
ONLY under
this point.
Back of
center
post
Knobs shown
removed for
viewing purposes
only.
1
Right
Stud
(A)
Knobs shown
removed for
viewing purposes
only.
2
Knobs shown
removed for
viewing purposes
only.
3
Left
Stud
Cable
Management
Openings
MF1U
Installation Instructions PAC-710
5
5. Place shelf around center post and level. (See Figure 6)
6. Raise shelf bracket and hook over shelf’s right stud. (See
Figure 6)
Figure 6
7. Turn both knobs clockwise to tighten the shelf in place. (See
Figure 6)
CAUTION: This shelf is intended for use with equipment
weighing not more than 25 lbs (11.34 kg) and having
dimensions that will permit it to sit evenly on this shelf. Use
with other equipment may result in instability causing
possible injury.
CAUTION: Do NOT sit or hang on the shelf. Such use may
result in instability causing possible injury and damage to
equipment.
CAUTION: Equipment MUST be fastened to the shelf
before moving the cart. If equipment is not fastened to the
shelf it MUST be removed before moving the cart.
Installing Safety Strap
1. Place equipment on shelf (A).
2. Thread strap (B) through slots in shelf (A). (See Figure 7)
Figure 7
3. Loop strap (B) over top of equipment and slide strap end
into clasp. (See Figure 8)
Figure 8
5
6
Knobs shown
removed for
viewing purposes
only.
RIght Stud
7
2
(A)
(B)
(B)
(A)
3
PAC-710 Installation Instructions
6
4. Pull strap (B) until tight around equipment and press clasp
closed to secure. (See Figure 9)
Figure 9
Cable Management
Follow cable management instructions in the cart installation
instructions.
(B)
(A)
4
Installation Instructions PAC-710
7
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P 800.582.6480 / 952.225.6000
F 877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P +31 (0) 495 580 852
F +31 (0) 495 580 845
Asia Pacific A Office No. 918 on 9/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
PAC-710 Installation Instructions
PAC-710 Installation Instructions
Chief, a products division of
Milestone AV Technologies
8800-002574 Rev00
2014 Milestone AV Technologies
www.chiefmfg.com
05/14
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief PAC710-G User manual

Category
Flat panel accessories
Type
User manual

Chief PAC710-G is a shelf accessory designed to be attached to Listed Chief MFC Series carts. It is intended to be used for supporting equipment such as video equipment, computer monitors, and other items that weigh less than 25 lbs (11.34 kg). The shelf is installed below the adjustment knob on the center post of the cart. It comes with a 6 ft. strap for securing equipment to the shelf. The shelf has cable management slots to help keep cords organized.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI