Chief JSB2090B Installation guide

Chief
Brand
Chief
Model
JSB2090B
Category
Mounting kits
Type
Installation guide

This manual is also suitable for

INSTALLATION INSTRUCTIONS
Instrucciones de instalación
Installationsanleitung
Instruções de Instalação
Istruzioni di installazione
Installatie-instructies
Instructions d´installation
Interface Bracket and Shelf Assembly
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
JSB2090
JSB2090 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the JSB2090 up to (and
including) the display does not exceed 35 lbs (15.9 kg).
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
IMPORTANT ! :
The JSB2090 interface brackets are
designed to be mounted to an already installed Chief TS218
swing arm.
--SAVE THESE INSTRUCTIONS--
Installation Instructions JSB2090
3
DIMENSIONS
LEGEND
23.50
596.8
7.87
200.0
7.87
200.0
270.4
10.65
20.3
204.5
8.05
0.80
17.42
442.4
325.5
243.4
9.58
12.81
9.94
252.4
2.25
10.85
275.6
4X 1.00
57.2
25.4
1/4-20 STUDS
107.50°
3.45
87.6
DIMENSIONS: INCHES
[MILLIMETERS]
Tighten Fastener
Apretar elemento de fijación
Befestigungsteil festziehen
Apertar fixador
Serrare il fissaggio
Bevestiging vastdraaien
Serrez les fixations
Loosen Fastener
Aflojar elemento de fijación
Befestigungsteil lösen
Desapertar fixador
Allentare il fissaggio
Bevestiging losdraaien
Desserrez les fixations
Open-Ended Wrench
Llave de boca
Gabelschlüssel
Chave de bocas
Chiave a punte aperte
Steeksleutel
Clé à fourche
Hex-Head Wrench
Llave de cabeza hexagonal
Sechskantschlüssel
Chave de cabeça sextavada
Chiave esagonale
Zeskantsleutel
Clé à tête hexagonale
JSB2090 Installation Instructions
4
TOOLS REQUIRED FOR INSTALLATION
PARTS
1/8"
(included)
A (1)
[Interface bracket]
B (1)
[Shelf assembly]
C (2)
[Clip]
D (2)
10-24 x 1/2"
E (4)
10-24
F (4)
1/4-20
G (4)
.750x.344x.500
H (4)
1"x1"
[Hook & loop]
J (1)
1/8"
Installation Instructions JSB2090
5
ASSEMBLY AND INSTALLATION
NOTE: The following procedure assumes that a Chief TS218
swing arm mount (not included) has already been
installed following instructions included with the mount.
1. Hook two clips (C) over top of display, with long edge of clip
on back of display. (See Figure 1)
Figure 1
2. Slide interface bracket (A) up from bottom along back of
display, ensuring that bottom of interface bracket hooks
over square extension on back of display. (See Figure 2)
3. Hang interface bracket onto studs at bottom of clips (C).
(See Figure 2)
Figure 2
4. Fasten interface bracket to clips using four 1/4-20 locknuts
(F). (See Figure 2)
5. Attach display to swing arm by lining up and inserting four
studs on interface bracket (A) into holes in swing arm. (See
Figure 3)
IMPORTANT ! : If attaching to the Chief TS318 swing
arm, use four .750x.344x.500 spacers (G) on the mount
studs before attaching the mount to the swing arm face.
6. Fasten display to swing arm using four 10-24 locknuts (E).
(See Figure 3)
Figure 3
7. Lift shelf assembly (B) up from below display and hook onto
interface bracket (A). (See Figure 4)
Figure 4
1
(C)
1
Back of
display
4
(F) x 4
2
(A)
(C)
Hook over
extension
bracket
Extension
bracket
6
(E) x 4
5
(Swing arm not shown for clarity)
7
(B)
(Display with
attached
interface
bracket)
Hook shelf
assembly
JSB2090 Installation Instructions
6
8. Fasten shelf assembly to interface bracket using two
10-24 x 1/2" buttonhead screws (D). (See Figure 5)
Figure 5
9. Put hook and loop (H) squares together so there are 2
squares.
10. Remove paper from one side of both of the squares.
11. Attach hook and loop squares to top of shelf assembly (B).
(See Figure 6)
Figure 6
12. Remove paper from hook and loop squares and place
remote phone on shelf assembly, pressing it against the
hook and loop squares. (See Figure 7)
Figure 7
(Swing arm not shown for clarity)
8
(D) x 2
(H) x 2
11
Remote phone
Installation Instructions JSB2090
7
JSB2090 Installation Instructions
USA/International A 6436 City West Parkway, Eden Prairie, MN 55344
P 800.582.6480 / 952.225.6000
F 877.894.6918 / 952.894.6918
Europe A Franklinstraat 14, 6003 DK Weert, Netherlands
P +31 (0) 495 580 852
F +31 (0) 495 580 845
Asia Pacific A Office No. 1 on 12/F, Shatin Galleria
18-24 Shan Mei Street
Fotan, Shatin, Hong Kong
P 852 2145 4099
F 852 2145 4477
Chief Manufacturing, a products division
of Milestone AV Technologies
8800-002280 Rev00
2012 Milestone AV Technologies, a
Duchossois Group Company
www.chiefmfg.com
10/12
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Chief JSB2090B Installation guide

Chief
Brand
Chief
Model
JSB2090B
Category
Mounting kits
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents