5 x
12G x 50mm
Timber Screws
3 x
Drywall Anchors
or Toggle Bolts
Screw in
stud centre
Ax a timber backboard spanning
2 studs using 12G x 75mm screws.
Suggested materials:
Melamine board
Pre-laminated MDF
Flooring Boards
Plywood
Suggested thickness:
15-25mm
Suggested size:
565mm W x 673mmm H
Install the wall bracket for the
Main Unit using the 4 corners
plus 2-4 more xings to secure
the bracket rmly in place.
Slide the “Spacer Mate” into position
making sure there is no play between
the bracket and the “Spacer Mate”.
Position the Sub Unit wall bracket
once again, making sure there is no
play between the brackets and the
“Spacer Mate”. Ax the Sub Unit
wall bracket placing a screw in each
corner plus 2-4 more xings to
secure the bracket rmly in place.
Once you have screwed in the
brackets you may remove the
“Spacer Mate” and mount the
units on the brackets.
Main Unit only
Main + Sub Units
Screw in
both sides
When installing a Main Unit, it is
recommended to x the supplied
wall mounting bracket to the
centre of a single stud. Use all 5
xings with heavy duty timber
screws to support the weight, then
use a minimum of 3 xings on
each side with either drywall
anchors or toggle bolts.
V21-02005
565
673
450
Backboard
Timber Stud
A
Backboard
Plasterboard
Timber stud
Backboard
anchor
screws
Main
Wall
Bracket
A
Main
Wall
Bracket
Main
Wall
Bracket
Spacer Mate
(Main to Sub)
Main
Wall
Bracket
Spacer Mate
(Main to Sub)
Sub
Wall
Bracket
© 2021 Energizer. Energizer and certain graphic designs are trademarks of Energizer Brands, LLC and related subsidiaries and are used under license by 8 Star Energy Pty Ltd.
All other brand names are trademarks of their respective owners. Neither 8 Star Energy Pty Ltd nor Energizer Brands, LLC is aliated with the respective owners of their trademarks.
STUD WALLS
Wall Bracket Mounting Instructions
