User
Manual
Step 1: Charge
Charge the LYT bottle cap fully
before use. Press activation button
to indicates battery life.
Green light indicates 40% - 100%
Orange light indicates 11% - 39%
Red light indicates 1% - 10%
Quick Start:
Step 4: Cap
Screw on the LYT
bottle cap and
tighten for proper
seal.
Step 3: Fill
Fill your bottle with
tap water. Note: not
suitable with water
from stream or a river.
Step 2: Activate Self-Cleaning
Press and hold the power button for 5
seconds to activate self-cleaning
mode. LED flashes three times to
indicate self-cleaning mode is active.
Once self-cleaning is activated, cap
will turn-on automatically every hour
for a few seconds to keep your bottle
odor-free.
5 seconds
Double
press
Step 5: Purify
Gently press button on top of cap 2
times to purify the water. This destroys
99.9% of e.coli in 3 minutes from your
drinking water. Product not tested on
viruses and pathogens.
Safety precautions:
Do not irradiate eyes with UV-C light
Not intended or not suitable for use by children
Do not activate the cap without installing on
the bottle
Use only with tap water or transparent water
source free of debris. Not suitable for water from
river or stream