SXBP2

Fluance SXBP2 User guide

  • I've reviewed the Mounting Guide for the FLUANCE Elite Bipolar SXBP2 Speaker. This document provides clear, step-by-step instructions for mounting the speaker, emphasizing the importance of stud mounting or, when necessary, using drywall anchors. It also includes diagrams with precise measurements for proper bracket placement. I'm ready to answer any questions you may have about this guide and its instructions.
  • What is the recommended method for mounting the speakers?
    What should I do if a stud is not available?
    Where should I place the first screw?
Elite Bipolar (SXBP2) Mounting Guide
We recommend anchoring your speakers by mounting them to a stud. A stud nder can be used to easily
locate them. Most homes are built with 16” (40.6 cm) on-center studs, which means there should be a stud
every 16” (40.6 cm). If you have trouble nding studs on a wall, verify how far apart they are in the home by
locating and measuring them on another wall. If a stud is not available, drywall anchors must be used.
If you require assistance, please do not hesitate to contact us at: www.uance.com/support
Mounting Steps
Place speaker in desired location and mark top edge (A).
Measure 3.5 cm (1.38 inches) down from the center of the top edge and mark the spot (B).
Measure 2 cm (0.79 inches) from that spot in each horizontal direction and mark (C). (Tip: It is best to
use a level to ensure all marks are aligned and level)
Install screws in both C marks.
Hang the speaker mount brackets on the screws and ensure the speaker is secure.
1.
2.
3.
4.
5.
*Note: Diagram not to scale
2 cm (0.79 in)
3.5 cm (1.38 in)
2 cm (0.79 in)
A
B
C C
/