1. PLUG AVX ADAPTER INTO PHONE
Plug the clear plastic modular plug (#1 in photo) on the AVX adapter into
the headset port on your phone.
2. CONNECT HEADSET INTO AVX ADAPTER
Plug the modular plug on the end of your headset cord* into the headset
port (#2 in photo) on the AVX adapter.
3. SET THE COMPATIBILITY SWITCH
Make a test call. After you are on the call, insert the end of the MIC ADJ
tool (#5 in photo) into the Compatibility Switch setting cavity (#3 in
photo). Start talking and push the switch sideways to the left (setting 1)
and then to the right (setting 2). Choose the one that makes your voice
sound the best to the person on the other end of the call. Keep the caller
on the phone for Step 4.
4. SET THE MICROPHONE VOLUME ADJUSTMENT
If the person on the other end of the call says that your voice is too loud
or too soft, increase or decrease the microphone volume as follows.
1. Hold the AVX adapter in position as shown (#4 in photo) with the
bottom label upright and facing you.
2. Insert MIC ADJ tool (#5 in photo) into the small hole on the bottom
of the unit (#4 in photo) and begin to talk. Instruct the person on the
other end of the call to tell you when your voice is at an acceptable level.
3. Turn the tool clockwise to increase the volume of your voice. Turn
counter-clockwise to decrease the volume of your voice
.
* If your headset does not end in a modular plug, you may need a lower cord for the headset. VXI sells lower headset
cords with VXI, Plantronics and GN Netcom compatible connectors. Visit www.vxicorp.com/passport for purchase or
call VXI at 1-800-742-8588. Tell the representative which headset brand you have and that you want to plug your
headset into the VXI AVX adapter.
Plantronics and GN Netcom are registered trademarks of their respective owners.
INSTALLATION
See photo reference, left
4. MIC ADJ
(microphone volume
adjustment)
3. COMPATIBILITY SWITCH (1 OR 2)
5. MIC ADJ TOOL
1. CONNECT INTO HEADSET
PORT ON THE PHONE
2. CONNECT
HEADSET HERE
VXI Corporation
www.vxicorp.com
1-800-742-8588
AVX Adapter
MIC ADJ
1 2
COMPATIBILITY
The VXI AVX Adapter allows a direct headset connection to the following
Avaya IP and standard phone models: 302D, 2410, 2420, 4406D+, 4412D+,
4424D+, 4424LD+, 6416D+M, 6424D+M sets. Also compatible with model
4620SW manufactured after November 2004.