2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Metra
  7. Dash kit

Metra Dash kit Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Metra Dash kit Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
APPLICATIONS
1-800-221-0932
metraonline.com
INSTALLATION INSTRUCTIONS FOR PART 99-7879
2011 Honda CR-Z
99-7879
•RecessedDINmountradioprovisionwithpocket
•ISOradiomountprovisionwithpocket
WIRING & ANTENNA CONNECTIONS(SoldSeparately)
Wireharness:70-1729
Antennaadapter:40-HD10
PanelRemovalTool(ATHKNGL)•PhillipsScrewdriver
CA
GF
B
D E
•A)RadioHousing•B)ISOBrackets•C)Pocket
•D)(11)#8X3/8”PhillipsTrussHeadscrews
•E)(2)#6X3/8”PhillipsPanHeadscrews
•F)(4)Whiteplasticclips•G)(1)Metalclip
TOOLS REQUIRED
KIT FEATURES
KIT COMPONENTS
Table of Contents
Dash Disassembly
–HondaCR-Z2011 3
Kit Assembly
–ISOmountradioprovisionwithpocket 4-5
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
99-7879
Caution
Metra recommends disconnecting the negative battery terminal before beginning any
installation. All accessories, switches, and especially air bag indicator lights must be
plugged in before reconnecting the battery or cycling the ignition.
*NOTE: Refer Also to the instructions included with the aftermarket radio.
1. Unclipandremovethelowerdashpanel
coverabovethepocketandremovethe
8mm/Phillipsscrew.(FiguresAandB)
2. Unclipandremovetheradiofromthe
dash.(Tip:startatthetopoftheradio)
(FigureC)
3. Unplugandremovetheradio.
Continued to kit assembly
3
Dash Disassembly
99-7879
(Figure A)
(Figure B)
(Figure C)
4
Kit Assembly
99-7879
(Figure A)
Hazard switch
Red factory clip
White
plastic
clips
White
plastic
clips
Metal clip
Air bag light
1. Removethecentertopclipoffofthe
factoryradioandinstallontothe
99-7879installkit.
2. Followthediagramtoattachthe
necessaryclipstotheradiohousingin
theproperlocations.
3. Remove2phillipsscrewsholdingthe
factoryhazardswitchforthefactory
panelandinstallintothe99-7879
re-usingthefactoryhardware.
4. Remove2phillipsscrewsholdingthe
passengerairbaglightfromthefactory
panelandinstallintothe99-7879
usingthesupplied#6screws.
5
ISO mount radio provision with pocket
99-7879
(Figure B)
(Figure C)
1. Locatethefactorywiringharnessinthe
dash.Metrarecommendsusingthe
propermatingadapterfromMetraor
AXXESS.Re-connectthenegative
batteryterminalandtesttheunitfor
properoperation.
2. Aligntheholesintheradiohousing
bracketswiththeholesintheISODIN
HeadUnitandsecurethebracketsto
theheadunitwiththescrewsincluded
withtheunit.(FigureB)
3. Attachthepockettothebracket/
radiohousingassemblywiththefour
#8X3/8”Phillipsscrewsprovided.
(FigureB)
4. Securetheradiohousingbracketsto
theradiohousingwithfour#8X3/8”
Phillipsscrewsprovided.(FigureC)
5. Reassembledashinreverseorderof
disassemblyusingthesupplied
#8screwinplaceofthefactoryscrew
removedinstepone,figureBofthe
dashdisassembly.
Notes
Notes
METRA. THE WORLD’S BEST KITS.™
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
1-800-221-0932
metraonline.com
INSTALLATION INSTRUCTIONS FOR PART 99-7879
REV. 5/05/11
/