ORION MOTOR TECH
Ford Cruise Control Switch User Installation Guide
Product Name: Cruise control switch
OEM Part #: SW-5928, F87Z-9C888-BB, F87A-9D809-BA
Warranty: 2 Years limited from seller
Installation Video: https://youtu.be/c2kOMRNU-YI
Detailed Installation Step:
TOOLS YOU WILL NEED
Part#
Tool Name
Illustration
1
Jaw Puller
2
Flat Head Screwdriver
3
Phillips Head Screwdriver
4
Socket Set
5
T45 Torx Driver
INSTALLATION INSTRUCTIONS
1. Disconnect The Negative Battery Cable.
2. Remove the two bolt hole covers on each side of the
steering wheel.
3. Remove the two 8mm airbag retaining bolts.
4. Carefully remove the airbag from the steering wheel and
disconnect the airbag harness. Set the airbag aside in a
safe, level area.
5. Remove the steering wheel from the steering wheel shaft
with a T45 Torx bit driver.
6. Before removing the steering wheel, disconnect the cruise
control electrical connector.
7. Assemble your two jaw puller. We utilized an appropriate
width socket between the center screw and the steering
shaft.
8. Using the correct socket, turn the jaw bolt clockwise until
the steering wheel is no longer pressed onto the shaft.
9. Place the wheel on a clean workbench and grab a small
flathead screwdriver and a phillips head screwdriver.
10. With the wheel facing up, remove the horn connections
with a small flat head screwdriver.
11. Remove the 4 phillips head screws holding the cruise
control buttons down.
12. Flip the wheel over and remove the two phillips head
screws securing the rear trim to the wheel.
13. Flip the wheel back over and remove the cruise control
buttons and wiring, paying close attention to how the button
harnesses are routed.
14. Install the new buttons and harness in the same
orientation as the factory buttons.
15. Install is reversal of removal being sure to add blue
loctite onto the steering wheel bolt.
/
