INST-910
Zirkona - Pistol Grip Scanner Mount
PS-001
7160-1380
Rev A
© Copyright 2019 Gamber-Johnson, LLC
Printing Spec:
1/1
The 7160-1380 is a pistol grip scanner mount designed to hold the scanner with the
face upward so the driver can see the screen if needed. It has a large slot for the pistol
grip to pass through. It needs to be positioned so the weight of the scanner holds it in
the tray. Do not position the scanner upward too much so the scanner could come out
of the mount. The scanner mount has 3 sets of the AMP's hole pattern, one on each
side and one in the end. The mount attaches to a motion attachment through one of
the AMP's hole patterns using the #10-32 mounting hardware supplied in hardware bag
7120-0914.
Below a is an exploded view showing the attachment of the 7160-1380 to a 1760-1261
(GJ kit # 7170-0764).
Revision Form
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Product
INSTALLATION INSTRUCTIONS
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brake lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
7160-1261
7160-1380
overhead
guard leg
/
