3
System Requirements
To use your printer and its software, your system should have:
â– For USB connections:
â– iMac
™
or Power Macintosh
®
G3 with built-in USB port
â– System 8.1 or later (iMac), System 8.5.1 or later(Power Macintosh G3)
Note:
If your system is running OS 8.1, you must download and install the
iMac Update 1.0 from Apple
®
at http://swupdates.info.apple.com
before you install the EPSON USB software. Contact Apple
Computer if you have problems installing this update. If your
system is running OS 8.5, you do not need to download and install
the update. Your operating system already includes full support for
the EPSON USB software.
■Shielded USB “AB” interface cable, from Series A (computer) to Series B
(printer), up to 6.5 feet (2 m) long.
Caution:
Using an improperly shielded USB cable—especially a cable more
than 6.5 feet (2 m) long—may cause the printer to malfunction.
â– For serial connections:
â– One of the following Macintosh models:
LC475, LC575, LC630; Quadra series; Centris series; PowerBook
®
series
(190, 520, 540, 550, or later); PowerBook Duo 280, 2300c/100; Performa
®
475, 575, 588, 630, 5210 or later; Power Macintosh series
â– System 7.5.1 or later (7.6 or later recommended)
â– ImageWriter
®
II serial cable or equivalent (8-pin mini DIN male/male, Belkin
brand recommended; EPSON part number: F2V024)
â– For all Macintosh computers:
â– At least 16MB of available RAM
â– At least 50MB of free hard disk space (100MB recommended)
â– 13-inch RGB display or better
â– Double-speed CD-ROM drive (quad-speed or faster recommended)
740i.book Page 3 Thursday, April 15, 1999 2:11 PM