Page is loading ...
English
1
Seidio Bluetooth GPS Receiver
RBT-1000 Quick Guide
Check the Package Content
Before you start using Seidio Bluetooth GPS Receiver, RBT-1000, please
check out if your package includes the following items. If any item is damaged
or missed, please contact your reseller at once.
RBT-1000
Power Switch, Power Jack & External Antenna Port
Right View
Power Jack
External
Antenna Port
Power
Switch
English
2
LED Display
Front View
1
Yellow LED indicates power is in charging
2
Blinking red LED indicates low power
3
Blinking Green LED indicates position is fixed
4
Blinking Blue LED indicates Bluetooth is connected
Getting Started
STEP 1: Charge the Battery
Before you use RBT-1000, the battery must be charged for at least four hours.
As RBT-1000 is in charging, the Yellow LED will be lighted up. When the
battery is fully charged, the Yellow LED will be turned off.
STEP 2: Turn on Receiver and wait for GPS fix
If the position has not been fixed yet, the Green LED will be still. If the position
has been fixed, the Green LED will be blinking.
STEP 3: Connect to Bluetooth-enabled handheld device
1. From your Bluetooth-enabled handheld device, execute Bluetooth
application software to search RBT-1000 and then connect it to your
Battery Status GPS Status Bluetooth Status
1
2
3
4
English
3
device. If the connection between your device and RBT-1000 is
successful, the Blue LED will be blinking.
2. Select correct bluetooth GPS device which name is BlueGPSXXXXXX
(see picture below).
STEP 4: Connect to your Navigation Software
Install and launch your navigation software in Navigation Software Kit and set
GPS configuration. Select correct COM port subject to the outbound
Bluetooth serial port of your handheld device and correct baud rate
depending on your navigation software.
•If you are required to type in pin code during configuration, please key in
“0000”.
How to replace Lithium-ion Battery
1. Open the bolt on the bottom cover of RBT-1000 and take the Lithium-ion
battery out.
2. Place new Lithium-ion battery into the room of RBT-1000.
The RBT-1000 Lithium-ion battery is replaceable and
rechargeable.
The RBT-1000 Lithium-ion battery can last more than 8 hours in
continuous operation mode.
How to use Car Charger to charge your handheld device
Connect car charger into your adapter connector of handheld device.
English
4
Tips
1. Place your RBT-1000 below the windshield without window film for car
navigation
2. It is suggested that use RBT-1000 under less shielded environment to
ensure better performance.
3. For the first position fix, please make sure your RBT-1000 is not in motion
but stationary and in open space so as to shorten the fix time.
/
