NEC SP-RM3 User manual

  • Hello! I am an AI chatbot trained to assist you with the NEC SP-RM3 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Version 1.0 - 20200630 1
User Manual
SP-RM3
Rear mounted speaker passive
Version 1.0 - 20200630 2
Index SP-RM3
Index …………………………………………………………………………………………………………… Page 02
Shipping content ………………………………………………………………..…………………………. Page 03
Assembly process ……………….…………………………………………………………………………… Page 04
Assembly instruction …………………………………………………………………………………………. Page 05
Technical specification ………………………………………..………………………………………….….. Page 06
Outlines ……………………………………………………….…………………………………………….…. Page 07
Version 1.0 - 20200630 3
Alternative mounting of SP-RM3 by using additional brackets for US Market (6)
Alternative mounting option 1 Alternative mounting option 2
1
2
3
4
Shipping Content SP-RM3
SP-RM3
1. 2x SP-RM3 Speaker
2. 4x M4 Screw
3. 4x M4 Washer
4. 4x Mounting bracket (pre-mounted to the speaker)
5. 4x additional mounting brackets (alternative mounting meeting ADA Guidelines in
US Market)
6. 2x Speaker cable (2m) (not shown here)
5
5
5
Version 1.0 - 20200630 4
1) Turn OFF the main power switch on the monitor.
2) Using two M4 screws, two washers, and the mounting brackets, attach the left speaker.
3) Repeat step 2 for the right speaker.
4) If needed, remove the handles from the monitor to be able to move the speakers behind the monitor.
5) Connect one end of the speaker cable to the bottom of the speaker (one cable per speaker). Connect the other end of each
speaker cable to the external speaker terminal on the monitor. Make sure the polarity is correct.
6) Set the monitor's terminal speaker switch to EXTERNAL.
Important NOTE :
The shown mounting position is holding the speaker visible from the front side of the display. This mounting position is
recommended for best sound quality results. However, to achieve a hidden installation, the speaker can be flipped to the
backside of the display (depending on the selected display model)
Not all displays, especially smaller sizes <42”, may allow a fully hidden installation of the speaker.
Assembly process SP-
2
Red number below indicates the process step
2
top side "up"
Version 1.0 - 20200630 5
Assembly instruction SP-RM3
Important NOTE :
The illustration shown is for reference purpose only.
Your display may slightly differ from the illustration.
Actual connections depend on the display model used.
Internal/External
speaker switch
EXTERNAL SPEAKER
TERMINAL
5
3
6
4
4
Version 1.0 - 20200630 6
Frequency range 80-20000 Hz
Sensitivity 72 dB
Rated Impedance 8 Ohm
Long term max. power 20 W
Net. Dimensions (1pcs) 370x60x60 mm
Net. Weight (1pcs) 1 kg
Packing gross dimension 420x220x130 mm
Packing gross weight 2,4 kg
Specification / Outlines SP-RM3
Version 1.0 - 20200630 7
Specification / Outlines SP-
/