Lithonia Lighting ELMLT Installation guide

  • I have reviewed the instructions for the Laser Remote Tester ELA LRT. This document explains how to use the laser to test emergency lighting and how to replace the batteries. I am ready to assist you with any questions you may have about this device or the instructions provided.
  • How do I test the emergency lighting unit?
    How long does the unit stay in test mode?
    How do I replace the batteries?
INSTRUCTIONS
ELA LRT
Laser Remote Test Accessory
Test Button
INSPECTION and MAINTENANCE
1. TO TEST: Press the "Test" button on the remote laser tester (see Fig. 1).
Aim the laser beam onto the red target label, located under the emergency
unit test switch (see Fig 2 below). The unit’s DC lamps will turn on, and the
unit will stay in this mode for three to thirty seconds, depending on emer-
gency unit model.
Fig.2
2. BATTERY REPLACEMENT: Replace only with laser manufacturer's recom-
mended replacement batteries. Unscrew the cap to which the key chain is
attached. Replace the batteries as shown in the laser manufacturers
instruction sheet. Fig.1
WARNING!
This is not a toy. This product emits laser radiation. Avoid
direct eye exposure. Follow safety procedures for use,
as directed in the laser manufacturers instructions.
LASER ACTIVATED
EMERGENCY LIGHTING SYSTEMS
TEL: 800-334-8694 Fax: 770-981-8141 www.lithonia.com
EMCSA00727
Revision D, April 2015
DISCONTINUED
/