OTC 6495 Operating instructions

Brand: OTC

Model: 6495

Type: Operating instructions

Sheet No.

Issue Date: Rev. B 6-16-04

Chrysler Harmonic Balancer Holding Ring

Form No. 107355

Operating Instructions

for: 6495

1 of 1

SPX Division

655 Eisenhower Drive

Owatonna MN 55060

Phone: (507) 455-7000

Tech. Serv.: (800) 533-6127

Fax: (800) 955-8329

Order Entry: (800) 533-6127

Fax: (800) 283-8665

International Sales: (507) 455-7223

Fax: (507) 455-7063

Use the following steps to remove the crankshaft bolt

from the crankshaft damper.

1. Place the pin side of the No. 6495 into the slots on the

crankshaft damper. See Figure 1.

2. Use a 1/2" breaker bar to hold the holding ring

against the crankshaft damper. Place the correct

socket with ratchet on the crankshaft bolt. Hold the

crankshaft damper and turn the crankshaft bolt

counterclockwise to loosen the bolt. See Figure 2.

The holding ring can also be used to tighten the crankshaft

bolt to factory torque specifications.

1. Place the pin side of the holding ring into the slots on

the crankshaft damper. See Figure 1.

2. Use a 1/2" breaker bar to hold the holding ring

against the crankshaft damper. Place the correct

socket with a torque wrench on the crankshaft bolt.

Hold the crankshaft damper and turn the crankshaft

bolt clockwise to tighten the bolt to the correct OE

torque specifications. See Figure 2.

Breaker Bar

Ratchet Wrench

Torque Wrench

Figure 1

Figure 2

WARNING: Wear eye

protection that meets ANSI

Z87.1 and OSHA standards.

Holding Ring

(6495)

Crankshaft Damper

OTC 6495 Operating instructions

OTC 6495 Operating instructions

OTC 6495 Operating instructions

Related papers

Other documents