Astria Fireplaces Gamma Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
Gamma
Type
Instruction Sheet

This manual is also suitable for

INSTALLING PERIMETER TRIM
1. Fireplace should be fully assembled. See Assembling Fireplace
in fi replace owner's manual.
2. Firmly snap trim assembly on shoulder screws. Shoulder screws
are located on fi replace cabinet (see Figure 2).
Side Trim
Mitered Edge
Shim
Adjusting
Plate
Set Screws Top Trim
Slot
Slot
Figure 1 - Assembling Trim
Figure 1 - Attaching Perimeter Trim to Fireplace
GAB SERIES PERIMETER TRIM KITS
P/N 107233-01
Rev. D, 04/2017
HEARTH PRODUCTS
KITS AND ACCESSORIES
GAB SERIES PERIMETER TRIM KITS
[FOR USE WITH MODELS VCM3026 AND GAMMA26]
KIT CONTENTS
1 ea. 3-Piece Trim Set
1 ea. Hardware Kit
1 ea. Instruction Sheet
Cat. No. Model Description
F1816 GAB6094 26" Perimeter Trim Kit, Black
F1817 GABP6094 26" Perimeter Trim Kit, Platinum
REQUIRED TOOLS AND SUPPLIES
Flat Blade Screwdriver
GENERAL INFORMATION
These perimeter trim kits are available in black and platinum
fi nishes
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE FIREPLACE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH THE
APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarifi cation of these instructions
or are not qualifi ed to properly install this kit, contact you local
distributor or dealer.
If any of these parts are missing or damaged, contact your dealer or
IHP.us.com for referral information.
ASSEMBLING PERIMETER TRIM
1. Remove packaging from three remaining pieces of trim.
2. Locate two adjusting plates with set screws, and two shims in
the hardware packet.
3. Align shim under adjusting plate as shown in Figure 14.
4. Slide one end of adjusting plate/shim in slot on mitered edge of
top trim (see Figure 1).
5. Slide other end of adjusting plate/shim in slot on mitered edge
of side trim (see Figure 1).
6. While fi rmly holding edges of trim together, tighten both set
screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Printed in U.S.A. © 2003 Innovative Hearth Products
P/N 107233-01 Rev. D 04/2017M
IHP reserves the right to make changes at any time, without notice, in design, materials, specifi cations, prices and also to discontinue colors, styles and products. Consult your local distributor for
fi replace code information.
1
IHP.us.com
Innovative Hearth Products (IHP)
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
  • Page 1 1

Astria Fireplaces Gamma Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
Gamma
Type
Instruction Sheet
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents