2. PRO SIGNAL
  3. PSG3394

PRO SIGNAL PSG3394 Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the PRO SIGNAL PSG3394 Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
24W Wallplate Amplier with BT Wireless
PSG3394
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
When using electrical appliances basic safety precautions should always be followed.
• To prevent re or shock hazard, do not expose this product to rain or moiure.
• Beware that liening for long periods at high volume levels may cause fatigue and
hearing damage.
OPERATION
INSTALLATION
• Allows connection of external audio source via cable or BT to integrated built in
speaker system.
• Connect the integrated speaker cables to the connector block on the rear of the
wallplate.
• Connect a 24VDC PSU to the power input cable socket noting the polarity.
• Install the wallplate onto the back box and secure with the 2 screws.
• The blue LED will flash approximately once per second indicating no devices are
connected.
• During pairing mode the LED with flash rapidly.
• Once pairing is successful the LED will flash once every 2 seconds.
• During audio streaming the LED will flash twice every 2 seconds.
• If connection is lost, the amplifier will automatically reconnect within 3 minutes or if
that fails will switch to pairing mode.
• Alternatively a source device can be connected directly to the 3.5mm stereo jack
socket on the front of the wallplate using a suitable cable.
BT input takes priority over cable connected devices.
• Adjust the volume level using the rotary control.
OVERVIEW
CLEANING & MAINTENANCE
• Clean the outside casing with a soft cloth lightly moistened with a mild detergent.
• Never use any abrasive or solvents.
SPECIFICATIONS
Audio Input 3.5mm stereo jack or Wireless BT
BT Version V4.2 aptX compliant
BT Receiving Range 50 meters (open space)
Amplier 24W (RMS) @ 4ohm Stereo Class D
THD 0.1% @ 4ohm, 1kHz
Power Requirements 24VDC 3A via PSU
• Pro-Signal declares that this radio equipment for wireless transmitter/receivers is in
compliance with Radio Equipment Directive 2014/53/EU
INFORMATION ON WASTE DISPOSAL FOR CONSUMERS OF ELECTRICAL &
ELECTRONIC EQUIPMENT.
When this product has reached the end of its life it must be treated as Waste Electrical & Electronic Equipment
(WEEE). Any WEEE marked products must not be mixed with general household waste, but kept separate for
the treatment, recovery and recycling of the materials used. Contact your local authority for details of recycling
schemes in your area.
Made in Taiwan
PO Box 13362 Dublin 2
PR2 9PP
Man Rev 1.1
/